Bissoy.com
Doctors Medicines MCQs Q&A

In a center tapped full wave rectifier, the input sine wave is 200sin50 ᴨt. If load resistance is of 1k then average DC power output of half wave rectifier is __________

In a center tapped full wave rectifier, the input sine wave is 200sin50 ᴨt. If load resistance is of 1k then average DC power output of half wave rectifier is __________ Correct Answer 16.20W

The equation of sine wave is in the form Em sin wt. On comparing Em = 200 Power = 4Em2/ ᴨ2RL = 800/ ᴨ2x 1000 = 16.20W.

Related Questions

In a half wave rectifier, the input sine wave is 200sin200 ᴨt Volts. If load resistance is of 1k then the average DC power output of half wave rectifier is __________
In a center tapped full wave rectifier, the input sine wave is 250sin100 ᴨt. The output ripple frequency of rectifier will be __________
In a center tapped full wave rectifier, the input sine wave is 20sin500 ᴨt. The average output voltage is __________
In a half wave rectifier, the sine wave input is 50sin50t. If the load resistance is of 1K, then average DC power output will be?
Consider the following statements. It converts the positive half cycle of the sinusoidal wave of the input to the pulsating DC output signal. It converts the positive half as well as negative half cycle of the sinusoidal wave of the input to pulsating DC output signal. Which of the following statements is CORRECT about half-wave rectifier?
DC power output of center tapped full wave rectifier is equal to ___________ (Im is the peak current and RL is the load resistance)
In a centre tapped full wave rectifier, the input sine wave is 250sin100t. The output ripple frequency will be _________
A system provides output yi(t) when xi(t) is applied. If the system is said to be LTI then which of the following properties must satisfy? (i).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) + by2(t) (ii).If the input is x(t – T), then the output must be y (t – T) (iii).If the input is x3 = ax1(t) + bx2(t), then output must be y3(t) = ay1(t) * by2(t) (iv).If the input is x(t – T), then the output must be y(t + T)
In a half wave rectifier, the input sine wave is 250sin100 ᴨt Volts. The output ripple frequency of rectifier will be __________
When we compare the half bridge converter and full bridge converter 1. The maximum collector current of a full bridge is only double that of the half bridge 2. Full bridge uses 4-power switches instead of 2, as in the double bridge. 3. Output power of a full bridge is twice that of a half bridge with the same input voltage and current. When of the above statements are correct?