Bissoy.com
Doctors Medicines MCQs Q&A

Consider the amplifier below for the case VDD = 5 V, RD = 24 kΩ, (W/L) = 1 mA/V2, and Vt = 1 V. For the input signal of 1.5V what is the value of the gain value obtained?

Consider the amplifier below for the case VDD = 5 V, RD = 24 kΩ, (W/L) = 1 mA/V2, and Vt = 1 V. For the input signal of 1.5V what is the value of the gain value obtained? Correct Answer -12.64 V/V

The amplitude of the output voltage signal that results is approximately equal to Voq – VOB = 2 – 0.61 = 1.39v. The gain implied by amplitude is Gain = -1.39/0.11 = -12.64 V/V.

Related Questions

Consider the amplifier below for the case VDD = 5 V, RD = 24 kΩ, (W/L) = 1 mA/V2, and Vt = 1 V. For amplifier biased to operate with an overdrive voltage of 0.5V, and disregarding the distortion caused by the MOSFET’s square-law characteristic, what is the largest amplitude of a sine-wave voltage signal that can be applied at the input while the transistor remains in saturation?
Consider the amplifier below for the case VDD = 5 V, RD = 24 kΩ, (W/L) = 1 mA/V2, and Vt = 1 V. If the amplifier is biased to operate with an overdrive voltage VOV of 0.5 V, find the incremental gain at the bias point.
A signal source of internal resistance 1.2 kΩ is connected to the input of an amplifier with a voltage gain of 140. What is the value of input resistance the amplifier should have to get an overall gain of 100?
Consider a system whose input r and output y are related by the equation $$y\left( t \right) = \int\limits_{ - \infty }^\infty {x\left( {t - \tau } \right)} h\left( {2\tau } \right)d\tau $$
Signal Processing mcq question image
Where h(t) is shown in the graph
Which of the following four properties are possessed by the system? BIBO: Bounded input gives a bounded output
Causal: The system is causal.
LP : The system is low pass.
LTI: The system is linear and time-invariant.
Consider the following statements about CMOS: 1. CMOS logic inverter has a maximum signal swing of 0 V to VDD. 2. The output signal swing is independent of the exact value of aspect ratio and other device parameters. 3. It is a fast switching device with wide noise margins. 4. It has zero input resistance and infinite output resistance. Which of these statements are correct?
Consider a voltage series feedback network, where amplifier gain = 100, feedback factor = 5. For the basic amplifier, input voltage = 4V, input current=2mA. Find the input resistance of the network.
Consider the following circuit. Given that VDD = 15V, VP = 2V, and IDS = 3mA, to bias the circuit properly, select the proper statement.
Two non-inverting amplifiers, with gain =1 and gain=20 are made using identical operational amplifiers. As compared to the unity gain amplifier, the amplifier with gain=20 has ___________
. A, B, C, D, E and F compared their marks in an examination and found that A obtained the highest marks, B obtained more marks than D, C obtained more than at least two others and £ had not obtained the lowest marks. Consider the following statements : Statement 1: At least two members obtained less marks than C Statement 2: E and F obtained the same marks Which of the above statement(s) is/are sufficient to identify the one with the , lowest marks ?
An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ & Output resistance of 2.5 kΩ.The input resistance of the current shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is