Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following is an essential requirement for a peak load plant?

Which of the following is an essential requirement for a peak load plant? Correct Answer Capability of quick start

The power plants to be employed as peak load plant should only have the capability of quick start, synchronization and taking up of system load and quick response to load variations.

Related Questions

Read the following statements: I. Diesel power plant is generally used as base load plant. II. Gas turbine power plant is used as peak load plant.
Consider the following statement: 1. Initial load tests and routine load tests are carried out on test piles and working Piles, respectively. 2. In a pile load test, the allowable load can be taken equal to half the ultimate load at which the total settlement amounts to one-tenth of the pile diameter. 3. In a pile load test, the allowable load can be taken equal to two-thirds of the total toad which causes a plastic settlement of 6 mm. Which of the above statements are correct?
Which of the following is the essential requirement of peak load plant?
Which of the following is an essential requirement for a peak load plant ___________
Which of the following statements is incorrect regarding to mountain ranges? 1) The highest peak of Satpura range is kalumar peak. 2) The highest peak of Vindhyan range is Dhoopgarh peak.
An inflow hydrograph is routed through a reservoir to produce an outflow hydrograph. The peak flow of the inflow hydrograph is PI and the time of occurrence of the peak is tI. The peak flow of the outflow hydrograph is P0 and the time of occurrence of the peak is t0. Which one of the following statements is correct?
Consider a symmetrical square wave of 20-V peak-to-peak, 0 average, and 2-ms period applied to a Miller integrator. Find the value of the time constant CR such that the triangular waveform at the output has a 20-V peak-to-peak amplitude.
Consider a square wave having a peak to peak amplitude of 275mv and it is amplified to a peak to peak amplitude of 4v, with rise time of 5.2µs. Calculate the slew rate?
Statement : The vehicular traffic has increased so much in the recent past that it takes at least two hours to travel between the city and the airport during peak hours.

Courses of Action :
I. Non-airport bound vehicles should not be allowed to ply on the road connecting the city and the airport.
II. The load of vehicular traffic should be diverted through various link roads during peak hours.
III. The departure and arrival of flights should be regulated so as to avoid congestion during peak hours.
If the peak load for a power plant equals the plant capacity then the ratio of the capacity factor to load factor will be _________________