Related Questions

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
D.C. motor is to a drive a load which is almost nil for certain part of the load cycle and peak value for short duration. We will select this
A Series motor
B Shunt motor
C Compound motor
D Any of the above
Saddle peak the highest peak of Andaman and Nicobar Islands is located in
A Great Nicobar
B Middle Andaman
C Little Andaman
D North Andaman
Supplies, plant maintenance, plant rent, plant insurance and cleaning labour comes under which type of costs?
A labour costs
B factory overhead costs
C finished costs
D manufacturing costs
In a power plant if the maximum demand on the plant is equal to the plant capacity, then
A Plant reserve capacity will be zero
B Diversity factor will be unity
C Load factor will be unity
D Load factor will be nearly 60%
The load factors for live load and dead load are taken respectively as
A 1.5 and 2.2
B 2.2 and 1.5
C 1.5 and 1.5
D 2.2 and 2.2
The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is
A $$\frac{5}{8}$$
B $$\frac{8}{5}$$
C $$\frac{5}{4}$$
D $$\frac{4}{5}$$
Which of the following is not a requirement for site selection of hydroelectric power plant?
A Large catchment area
B Rocky land
C Sedimentation
D Availability of water
The coal requirement per kW hour generation in the thermal power plant is of the order of
A 0.1 to 0.2 kg
B 0.2 to 0.4 kg
C 0.6 to 0.8 kg
D 1.0 to 1.5 kg

Next steps