Bissoy.com
Doctors Medicines MCQs Q&A

Consider a symmetrical square wave of 20-V peak-to-peak, 0 average, and 2-ms period applied to a Miller integrator. Find the value of the time constant CR such that the triangular waveform at the output has a 20-V peak-to-peak amplitude.

Consider a symmetrical square wave of 20-V peak-to-peak, 0 average, and 2-ms period applied to a Miller integrator. Find the value of the time constant CR such that the triangular waveform at the output has a 20-V peak-to-peak amplitude. Correct Answer 0.50ms

According to the question 1/CR = 2.

Related Questions

Which one of the following is the correct sequence of various stages of operating cycle of a manufacturing company?  1. Raw material conversion period, work-in-progress conversion period, Finished goods conversion period, Receivables conversion period 2. Raw material conversion period, work-in-progress conversion period, Creditors payment period, Receivables conversion period 3. Creditor payment period. Raw material conversion period, Receivables conversion period, work-in- progress conversion period 4. Raw material conversion period, Finished goods conversion period, work-in- progress conversion period. Receivables conversion period 
Given below are three quantities named 1, 2 and 3. Based on the given information, you have to determine the relationship between the three quantities. You should use the given data and knowledge of Mathematics to choose between the possible answer. Quantity 1: Area of the innermost square. A square is made by joining the midpoints of a square of area 200 sq. m. The outermost square is called Square 1, The square inside it is called Square 2. The next square is made by joining midpoints of square 2 and is called Square 3. This process goes on. Square 5 is the innermost square. Quantity 2: A man starts with a speed of 10 km/hr. He increases his speed by 10 km/hr every hour at the start and drives at the same speed for that hour. If he traveled a total distance of 550 km. Find the time Quantity 3: Height of cylinder Its volume is equal to the volume of a cone whose radius is 14 cm and height is 39.3 cm. The radius of the cylinder is 14 cm
Which of the following is/are not true for a triangular pyramid? (a) Triangular pyramid has six faces. (b) Triangular pyramid has four vertices. (c) Triangular pyramid has six edges. (d) The sum of the number of faces, vertices and edges of a triangular pyramid is 14. (e) Triangular pyramid is also known as a tetrahedron.
Consider a Miller integrator with a time constant of 1ms and an input resistance of 10 kΩ. Let the op amp have VOS (offset voltage) = 2 mV and output saturation voltages of ±12 V. Select the largest possible value for a feedback resistor RF so that at least ±10 V of output signal swing remains available.
Consider a Miller integrator with a time constant of 1ms and an input resistance of 10 kΩ. Let the op amp have VOS (offset voltage) = 2 mV and output saturation voltages of ±12 V. Assuming that when the power supply is turned on the capacitor voltage is zero, how long does it take for the amplifier to saturate?
Consider a Miller integrator with a time constant of 1ms and an input resistance of 10 kΩ. Let the op amp have VOS (offset voltage) = 2 mV and output saturation voltages of ±12 V. What is the corner frequency of the resulting STC network?
Given that the charging current of capacitor is constant in a monostable multivibrator using IC 555, then find the type of output waveform, type of capacitor voltage waveform and the time period of output.
In the figure, D1 is a real silicon p-n junction diode with a drop of 0.7 V under forward bias condition and D2 is a Zener diode with breakdown voltage of -6.8 V. The input Vin(t) is a periodic square wave of period T, whose one period is shown in the figure. Assuming 10τ ≪ T, where τ is the time constant of the circuit, the maximum and minimum values of the output waveform are respectively,
Which of the following inverter output waveforms are better compared to a square wave? 1. Quasi sine wave 2. Pulse Width Modulation 3. Sine wave 4. Triangular wave
For the given circuit, what is the minimum peak value of the output waveform if the input waveform is 10V square wave with switching time of 1 second? Assume that the input switches between +10V and -10V DC levels.