Won't it be better if we start with a C-cut (a segment of the circle to be drilled), then gradually tilt the tool to cover the entire circle? Is the 'rotational movement' you are using necessary once you get a bite? What if the tool is held perfectly vertical and steady at low RPM?

Question

Won't it be better if we start with a C-cut (a segment of the circle to be drilled), then gradually tilt the tool to cover the entire circle? Is the 'rotational movement' you are using necessary once you get a bite? What if the tool is held perfectly vertical and steady at low RPM?

Share with your friends

Talk Doctor Online in Bissoy App

Dr. Md Rushad Rahman · Answer 1 · Apr 07, 2018 08:12:42

if you tilt the bit, the edge of the hole is parabolic and not circular. "Hole saws" for larger-diameter holes usually have a drill bit in the center that either sets or benefits from a pilot hole, so tilting might be highly problematic with the hole saw. For smaller-diameter holes this is not an issue, but also there's no real advantage to tilting at the beginning of the cut.

Won't it be better if we start with a C-cut (a segment of the circle to be drilled), then gradually tilt the tool to cover the entire circle? Is the 'rotational movement' you are using necessary once you get a bite? What if the tool is held perfectly vertical and steady at low RPM?

1 Answers