After sanding, remove the dust with a tack cloth and apply three coats of polyurethane finish, sanding between coats with a #00 steel wool. After that, buff the surface with...
1 Answers 1 viewsYou can make your own, by rolling up paper tightly and even shape it using sandpaper. You don’t use glue, just tape up one end to secure it.
1 Answers 1 viewsYes, you can. However, when you are trying to open it after compression (assuming you deleted the original), then you will have to wait until it is extracted again, which...
1 Answers 1 viewsFor a 16 mm hole, I do not believe there is a Rawl plug. Use a Dyna bolt or AnkaScrew.
1 Answers 1 viewsTry going to "System Preferences," then go to "Select Displays," and click "Scaled." Finally, select a lower resolution. If you see icons with different-sized previews of text, select the icon...
1 Answers 1 viewsIf it is a split Babbitt, you will have a gasket between the two halves that allow for tightening due to wear. The procedure pretty much leaves it size to...
1 Answers 1 viewsIt totally depends on the kind of laminate you're going for. The cheaper stuff costs 80-90 cents a square foot, but depending on the quality and style, it can cost...
1 Answers 1 viewsWhen you buy a ceiling fan, there's usually a recommended ceiling area that would be compatible with that fan. Therefore, be sure to know how big your ceiling area is,...
1 Answers 1 viewsThe same: either a 42S or 42R. Most overcoats are pre-measured to fit over a suit, so shop for the same size you normally wear.
1 Answers 1 viewsYou would likely need a large or XL depending on the brand's cut, etc. I would suggest trying the clothes on or ordering from a provider who allows free returns.
1 Answers 1 views