Bissoy.com
Doctors Medicines MCQs Q&A

When earth fault occurs:

When earth fault occurs: Correct Answer Voltage potential at the earth mat increases due to earthing

Increase in voltage potential at the earth mat caused by electrical faults that occur at electrical substations, power plants, or high voltage transmission lines.

When fault occurs, short circuit current flows through the equipment and into the grounding electrode. The resistance of the Earth is non-zero, so current injected into the earth at the grounding electrode produces a potential rise with respect to a distant reference point.

Related Questions

Which of the following statements is/are correct? 1. The earth is nearest to the Sun at Perihelion, which generally occurs on January 3. 2. The earth is farthest away from the Sun at Perihelion, which generally occurs on July 4. 3. The earth is farthest away from the Sun at Aphelion, which generally occurs on July 4. 4. The earth is nearest to the Sun at Aphelion, which generally occurs on January 3. Select the correct answer using the code given below:
The phases of the moon as we see from the Earth are due to changing relative positions of the sun, the earth and the moon. Which of the following statements is true. A. on a full moon day, the earth comes between the sun and the moon B. on a new moon day, the moon is in between the earth and the sun C. on a full moon day, the moon is in between the earth and the sun D. on a new moon day, the earth is between the sun and the moon? E. on a new moon day, the sun is between the moon and the earth
A sustained three phase fault occurs in the power system shown in the figure. The current and voltage phasors during the fault (on a common reference), after the natural transients have died down, are also shown. Where is the fault located?  
Three – phase to ground fault takes place at locations F1 and F2 in the system shown in the figure If the fault takes place at location F1, then the voltage and the current at bus A are VF1 and IF1 respectively. If the fault takes place at location F2, then the voltage and the current at bus A are VF2 and IF2 respectively. The correct statement about voltages and currents during faults at F1 and F2 is
The following question has three statements. Study the question and the statements to decide which of the statement(s) is/are necessary to answer the question. A train starts from point A towards point B, but after ‘n’ hours, its speed becomes 2/3rd of the normal speed due to some fault. Find the value of n. Statement I: The fault occurred at a distance of 800 km from the destination Statement II: Had the fault occurred 200 km further, the train would have got late by 30 min Statement III: The train got late by 40 min
Calculate the value of the fault impedance if the fault voltage is 2 V and fault current is 4 A.
The fault not belonging to the classification of fault with the attitude of fault as basis ___________
The fault where fault strike is parallel to the dip of the layers broken and disrupted by the fault?
The fault which is the result of both fault scarps and fault-line scarps is?
The higher the width of the stacking fault _________ will be the stacking-fault energy. Higher the stacking fault energy __________ will be the cross slip.