Bissoy.com
Doctors Medicines MCQs Q&A

In the full-wave rectifier circuit shown in the figure, the diodes that conduct when the positive half-wave of AC signal applied are:

In the full-wave rectifier circuit shown in the figure, the diodes that conduct when the positive half-wave of AC signal applied are: Correct Answer D<sub>1</sub>, D<sub>2</sub>

Positive-half cycle:

During the positive half cycle of the supply, diodes D1 and D2 conduct in series while diodes D3 and D4 are reverse biased and the current flows through the load as shown in the figure below.

Related Questions

Diode in small signal positive halfwave rectifier circuit acts as
A positive small signal halfwave rectifier can
For the rectifier circuit shown in the figure, the sinusoidal voltage (V1 or V2) at the output of the transformer has a maximum value of 10 V. The loadresistance RL, is 1 k$$\Omega $$. If lav is the average current through the resistor RL, the circuit corresponds to a
Electronics mcq question image
In the below shown diode rectifier circuit, The diodes D1, D2 & D3 are connected to phases R,Y and B respectively as shown The phase sequence is R-Y-B. The diode D1 would conduct from
The I – V characteristics of the zener diodes D1 and D2 are shown in Figure I. These diodes are used in the circuit given in Figure II. If the supply voltage is varied from 0 to 100 V, then breakdown occurs in.
Which of the following statements are not correct? (A) Precision rectifiers use positive feedback to compensate for the forward drop of the diodes (B) Precision peak detector uses a capacitor to effectively lengthen the duration of the peaks (C) Limiters may be thought of as programmable signal clippers (D) In order to improve performance of comparators negative feedback may be used (E) There are two basic approaches for realizing a design : (1) using zener diodes and (2) using biased-signal diode network Choose the most appropriate answer from the options given below: (1) (A) and (D) only (2) (D) and (E) only (3) (A) and (C) only (4) (B) and (D) only
In the given diode rectifier circuit, The diodes D1, D2 & D3 are connected to phases R,Y and B respectively as shown. The phase sequence is R-Y-B. The diode D1 would conduct from
From the diode rectifier circuit shown below, with phase sequence R-Y-B, diodes D3 & D5 conduct when
If diodes are ideal in the circuit shown in the given figure, then determine the maximum value of Vout during the positive half of the input signal.
In the below shown diode rectifier circuit, The diodes D1, D2 & D3 are connected to phases R,Y and B receptively as shown The phase sequence is R-Y-B. The diode D3 conducts from