Bissoy.com
Doctors Medicines MCQs Q&A

A positive small signal halfwave rectifier can

A positive small signal halfwave rectifier can Correct Answer Rectify signals with both peak value and down to few millivolts

A positive small signal halfwave rectifier can rectify signals with peak values down to few millivolts, because the high open loop gain of the op-amp automatically adjusts the voltage drive to the diode, so that the rectified output peak is the same as the input.

Related Questions

Diode in small signal positive halfwave rectifier circuit acts as
Some small cubes of same height 7 cm but variable length and width are put inside a large cuboid of height 21 cm. Length and width of cuboid is 32 cm and 24 cm, respectively. Small cubes are put such that cubes at the bottom most layer is of similar base area; second layer contains all the cubes of similar base area and third layer have all the cubes of similar base area. Which of the following statement(s) given below is / are TRUE? A: If side of each small cubes at bottom most layer is 8 cm, then maximum number of small cubes that can be put at bottom most layer is 12. B: If maximum of 48 cubes can be put at second layer, then side of each cube at second layer is 6 cm. C: If side of each small cubes at third layer is 1.6 cm, then maximum number of small cubes that can be put at third layer is 300.
Consider the following statements. It converts the positive half cycle of the sinusoidal wave of the input to the pulsating DC output signal. It converts the positive half as well as negative half cycle of the sinusoidal wave of the input to pulsating DC output signal. Which of the following statements is CORRECT about half-wave rectifier?
Consider the following statements regarding modulation : 1. The communication systems, where a weak signal is transmitted by the use of a modulation is essential in carrier signal. 2. When the frequency of the high frequency signal is varied in accordance with the intensity of the low-frequency weak signal, the modulation is said to be frequency modulation. 3. The process of recovering original baseband signal from the modulated signal is called phase modulation. Which of the above statements are correct ? 
The accompanying image shows a large cube made of dark and white small sugar cubes. Small cubes of the diagonally arranged row of the bottom surface of the large cube, small cubes of the row with one face on the right-hand surface of the large cube, small cubes of the row with one face on the front surface of the large cube, and small cubes of the column with one face on the top of large cube surface are all dark. Select the number of small white cubes of the large cube.
Match the following: (i) Half wave rectifier p) Transformer not required (ii) Full wave rectifier  q) Centre tap transformer required (iii) Full wave bridge rectifier r) Ordinary transformer required
Consider the following solution to the producer-consumer synchronization problem. The shared buffer size is ?. Three semaphores empty, full and mutex are defined with respective initial values of 0, ? and 1. Semaphore empty denotes the number of available slots in the buffer, for the consumer to read from. Semaphore denotes the number of available slots in the buffer, for the producer to write to. The placeholder variables, denoted by P, Q, R, and S, in the code below can be assigned either empty or full. The valid semaphore operations are: wait ( ) and signal ( ). Producer: Consumer: do {         wait (P) ;         wait (mutex) ;         //Add item to buffer         signal (mutex) ;         signal (Q) ; } while (1) ; do {          wait (R) ;          wait (mutex) ;          //Consume item from buffer          signal (mutex) ;          signal (S) ; } while (1) ;   Which one of the following assignments to P, Q, R and S will yield the correct solution?
A rectangular pulse train s(t) as shown in the figure is convolved with the signal cos2(4π × 103t). The convolved signal will be a
Signal Processing mcq question image
Large, medium and small ships are used to bring water. 4 large ships carry as much water as 7 small ships, 3 medium ships carry the same amount of water as 2 large ships and 1 small ship. 15 large, 7 medium and 14 small ships, each made 36 journeys and brought a certain quantity of water. In how many journeys would 12 large, 14 medium and 21 small ships bring the same quantity ?
Below are given two sets, Set - I which gives modalities of operant conditioning and Set - II which provides the types of reinforcement, the types of responses (responses made or withheld) and the presence or absence of cue. Match the two sets and indicate your answer by choosing from the code : Set - I (Modalities of operant conditioning procedures) Set – II           (Conditions and contexts) (a) Reward training (i) Positive reinforcement, response made, with cue present (b) Escape training (ii) Positive reinforcement, response withheld with cue absent (c) Discriminated omission training   (iii) Positive reinforcement, response made with cue absent (d) Active avoidance   (iv) Negative reinforcement, response made with training (e) Punishment training (v) Positive reinforcement, response withheld with cue present   (vi) Negative reinforcement, response withheld with cue absent