Related Questions

Costing system, which omits some of journal entries in accounting system is known as
A in-time costing
B trigger costing
C back flush costing
D lead time costing
In an accounting system, document which supports journal entries is classified as
A cost document
B priced document
C source document
D direct document
Which of the following is a type of cash receipt journal + cash payment journal?
A Bank statement
B Statement of cash flow
C Cash book
D Cash documents
When the length of the journal is equal to the diameter of the journal, then the bearing is said to be a
A Short bearing
B Long bearing
C Medium bearing
D Square bearing
In an oil lubricated journal bearing, the coefficient of friction between the journal and the bearing
A Remains constant at all speeds
B Is minimum at zero speed and increases monotonically with increase in speed
C Is maximum at zero speed and decreases monotonically with increase in speed
D Becomes minimum at an optimum speed and then increases with further increase in speed
In a journal bearing, the load on the bearing is __________ to the axis of the journal.
A Parallel
B Perpendicular
C Both A and B
D None of these
In a partial journal bearing, the angle of contact of the bearing with the journal is
A 120°
B 180°
C 270°
D 360°
In a full journal bearing, the angle of contact of the bearing with the journal is
A 120°
B 180°
C 270°
D 360°
For a two stage compressor, if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will
A Increase
B Decrease
C Remain unaffected
D Other factors control it
Otto cycle efficiency is higher than Diesel cycle efficiency for the same compression ratio and heat input because in Otto cycle
A Heat rejection is lower
B Expansion and compression are isentropic
C Combustion is at constant volume
D Maximum temperature is higher

Next steps