Related Questions

In an oil lubricated journal bearing, the coefficient of friction between the journal and the bearing
A Remains constant at all speeds
B Is minimum at zero speed and increases monotonically with increase in speed
C Is maximum at zero speed and decreases monotonically with increase in speed
D Becomes minimum at an optimum speed and then increases with further increase in speed
In a journal bearing, the load on the bearing is __________ to the axis of the journal.
A Parallel
B Perpendicular
C Both A and B
D None of these
In a partial journal bearing, the angle of contact of the bearing with the journal is
A 120°
B 180°
C 270°
D 360°
In a full journal bearing, the angle of contact of the bearing with the journal is
A 120°
B 180°
C 270°
D 360°
If p = bearing pressure on projected bearing area, Z = absolute viscosity of lubricant and N = speed of journal, then the bearing characteristic number is given by
A $$\frac{{{\text{ZN}}}}{{\text{p}}}$$
B $$\frac{{\text{p}}}{{{\text{ZN}}}}$$
C $$\frac{{\text{Z}}}{{{\text{pN}}}}$$
D $$\frac{{\text{N}}}{{{\text{Zp}}}}$$
In a boundary lubricated bearing, there is a __________ of lubricant between the journal and the bearing.
A Thick film
B Thin film
C Either A or B
D None of these
A sliding bearing which can support steady loads without any relative motion between the journal and the bearing, is called
A Hydrostatic lubricated bearing
B Hydrodynamic lubricated bearing
C Boundary lubricated bearing
D Zero film bearing
The frictional torque transmitted in a flat pivot bearing, considering uniform wear, is (where μ = Coefficient of friction, W = Load over the bearing and R = Radius of bearing surface)
A $$\frac{1}{2}$$μWR
B $$\frac{2}{3}$$μWR
C $$\frac{3}{4}$$μWR
D μWR
When the bearing is subjected to large fluctuations of load and heavy impacts, the bearing characteristic number should be _________ the bearing modulus.
A 10 times
B 5 times
C 15 times
D 20 times
নয়টি বেলনাকৃতির তার, যাদের প্রতিটির ব্যাস d ও দৈর্ঘ্য L, একত্রে শ্রেণি সজ্জায় সংযুক্ত আছে। সজ্জাটির রোধ যদি একটি L দৈর্ঘ্যের বেলনাকৃতির তারের রোধের সমান হয়, তবে তারটির ব্যাস কত? (Nine cylindrical wires each of diameter d and length L are connected in series. If the resistance of the connection is equal to the resistance of another cylindrical wire of length L, then what is the diameter of the wire?)
A 3d
B 9d
C d3
D d9

Next steps