Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Arrange the following activities with regard to rehabilitation in industries.
1. Assessment of feasibility
2. Assessment of additional funds
3. Preparation of cash flow statements
4. Arrangement of funds with other creditors
5. Marketing arrangement
6. Arrangement for disposal of unwanted assets and recovery of over due debts
7. Arrangement with various financial institutions
8. Arrangement fir Management Performance
When a closely-coiled helical spring of mean diameter (D) is subjected to an axial load (W), the deflection of the spring ($$\delta $$) is given by (where d = Diameter of spring wire, n = No. of turns of the spring and C = Modulus of rigidity for the spring material)
A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be
An open coiled helical compression spring 'A' of mean diameter 50 mm is subjected to an axial load ‘W’. Another spring 'B' of mean diameter 25 mm is similar to spring 'A' in all respects. The deflection of spring 'B' will be __________ as compared to spring 'A'.
In a vehicle with torque tube drive, the rear suspension spring
Recently, the USA decided to support India's membership in multilateral export control regimes called the "Australia Group" and the "Wassenaar Arrangement". What is the difference between them? 1. The Australia Group is an informal arrangement which aims to allow exporting countries to minimize the risk of assisting chemical and biological weapons proliferation, whereas the Wassenaar Arrangement is a formal group under the OECD holding identical objectives. 2. The Australia Group comprises predominantly of Asian, African and North American countries, whereas the member countries of Wassenaar Arrangement are predominantly from the European Union and American continents. Which of the statements given above is/are correct? 
A block of mass M is attached to the lower end of a vertical spring. The spring is hung from a ceiling and has a force constant value k. The mass is released from rest with the spring initially unstretched. The maximum extension produced in the length of the spring will be:
Consider the following statements regarding suspension cables: 1) The horizontal component of the cable tension in a suspension bridge is constant at every point along the length of the cable 2) Stiffening girders in a suspension bridge carry only the live load Which of the above statements is/are correct?
A 10 kW, 400 V, 3-phase, 4-pole, 50 Hz induction motor develops the rated output at rated voltage with its slip rings shorted. The maximum torque is twice the full load torque occurs at the slip of 10% with zero external resistance in the rotor circuit. An external resistance is now tripled in the rotor circuit. Then the slip at which maximum torque occur for the same load torque is?
For a three phase induction motor, maximum torque is double the full load torque and starting torque is 1.6 times the full load torque. To get a full load slip of 5%, percentage reduction in the rotor resistance should be?