Related Questions

Rashna Company collected the following data in its accounting records in 2014 : From the income statement : Depreciation expense Tk. 1,000 Loss on sale of equipment 3,000 From the comparative balance sheet : Beginning balance , equipment Tk. 12,500 Ending balance , equipment 8,000 Beginning balance , accumulated depreciation 2,000 Ending balance , accumulated depreciation 2,400 No new equipment was purchased during the year. The equipment was sold at the end of the year. What was the cash in -flow from the sale of equipment in 2014?
A Tk, 3,900
B Tk. 1,000
C Tk. 900
D Tk. 600
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
A Working
B Damaging
C Allowable
D None of these
If Q is load factor, S is shape factor and F is factor of safety in elastic design, the following:
A Q = S + F
B Q = S - F
C Q = F - S
D Q = S × F
Factor of safety (i.e., overdesign factor) in heat transfer equipments is about __________ percent more than the actual/theoretical design factor.
A 5-10
B 15-20
C 30-35
D 35-40
Factor of safety in machine design is defined as the ratio of ultimate stress to __________ stress.
A Working
B Bearing
C Yield
D None of these
There are two domains on your network. The DESIGN domain trusts the SALES domain. A color printer is shared in the DESIGN domain, and print permissions have been granted to the Domain Users and Domain Guests groups in the DESIGN domain. The Guest account has been enabled in the DESIGN domain. User John Y logs on using his account in the SALES domain. What must you do to allow JohnY to access the printer?
A Make JohnY a member of the DESIGN Domain Guests group
B Make JohnY a member of the DESIGN Domain Users group
C Do nothing. JohnY can access the printer now
D JohnY cannot access the printer with this configuration
E None of the above
Following the six-tenth factor rule, if a log-log plot of capacity of the equipment vs. cost of the equipment is made, then a straight line is obtained, whose slope is equal to
A 0.1
B 0.6
C 0.2
D 0.8
Factor of safety is defined as the ratio of
A Ultimate stress to working stress
B Working stress to ultimate stress
C Breaking stress to ultimate stress
D Ultimate stress to breaking stress
For the design of retaining walls, the minimum factor of safety against overturning is taken as
A 1.5
B 2.0
C 2.5
D 3.0
The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using
A Gerber relation
B Soderberg relation
C Goodman relation
D None of these

Next steps