Related Questions

3/4th of square were taken to form shape A and the rest was made to form shape B. Shape A was divided into four equal squares (Shape C), what will be the ratio of the one shape C to one shape B.
A 1:4
B 3:16
C 1:2
D 3:4
The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.
A Working
B Damaging
C Allowable
D None of these
Three elastic constants for a completely anisotropic elastic material which follows the Hooke's law are young's modulus, elastic limit stress and yield stress. Which of the following properties is most sensitive to increase in strain rate ?
A Tensile strength
B Elastic limit
C Proportional limit
D Yield strength
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
A highly elastic material is deformed least on loading and retains its original form on removal of the load. Which of the following is the most elastic material?
A Steel
B Glass
C Rubber
D Brass
There are two domains on your network. The DESIGN domain trusts the SALES domain. A color printer is shared in the DESIGN domain, and print permissions have been granted to the Domain Users and Domain Guests groups in the DESIGN domain. The Guest account has been enabled in the DESIGN domain. User John Y logs on using his account in the SALES domain. What must you do to allow JohnY to access the printer?
A Make JohnY a member of the DESIGN Domain Guests group
B Make JohnY a member of the DESIGN Domain Users group
C Do nothing. JohnY can access the printer now
D JohnY cannot access the printer with this configuration
E None of the above
Factor of safety (i.e., overdesign factor) in heat transfer equipments is about __________ percent more than the actual/theoretical design factor.
A 5-10
B 15-20
C 30-35
D 35-40
Which of the following relationships is correct for relating the three elastic constants of an isotropic elastic material (where, E = Young's modulus, G = Modulus of rigidity or shear modulus v = Poisson's ratio)?
A E = 2G (1 + v)
B E = G (1 + v)
C $${\text{E}} = \frac{{{\text{G}}\left( {1 + {\text{v}}} \right)}}{2}$$
D E = 2G (1 + 2v)
All materials obey Hooke's law within elastic limit. When elastic limit is reached, the tensile strain
A Increases very quickly
B Decreases very quickly
C Increases in proportion to stress
D Decreases in proportion to stress
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm

Next steps