Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C.
Which of the following statements is correct regarding the oxidation number of Oxygen? I. The oxidation number of Oxygen in most compounds is -2. II. When Oxygen is bonded to Fluorine in compounds like Oxygen difluoride and Dioxygen diflouride, the Oxygen is assigned an oxidation number of +2 and +2 respectively. III. In peroxide, an Oxygen atom is assigned an oxidation number of -1 and in Superoxide, each oxygen atom is assigned an oxidation number of -1/2.
Pure carbon is completely burnt in oxygen. The flue gas analysis is 70% CO2, 20% CO and 10% O2. The percent excess oxygen used is
Determine the height of the chimney to produce a static draught of 22mm of water if the mean flue gas temperature in chimney is 290oC and ambient temperature in boiler house is 20oC. The gas constant for air is 29.26Kgm/Kgk and for chimney flue gas is 26.2 Kgfm/Kgk. Assume reading as 760mm of mercury?
Thermal conductivity based continuous flue gas analyser makes use of varying thermal conductivity of the constituents of flue gases. Which of the following constituents of flue gases has the maximum thermal conductivity?
A draught of 15mm of water is produced by using a chimney of height 30m. The ambient air and flue gases are at 27oC and 300oC respectively. The coal burned on the grate contains 81% carbon, 5% moisture and remaining ash. Neglect the losses and assume values of burnt products equivalent to the volume of air supplied and for the complete combustion of fuel, find the percentage of excess of air supplied?
A 15kg of air is supplied per kg of fuel burnt to the combustion chamber of a boiler using fuel 600kg/hr. the temperature of flue gases and ambient air are 273°C and 32°C. If the minimum draught required to start the flue is 9.5mm of water, find out the minimum height of the chimney?
Which of the following are essential for a good combustion chamber of turbojet engine? 1. It should allow complete combustion of fuel. 2. It should maintain sufficiently high temperature in the zone of combustion in addition to proper atomization of fuel thus leading to continuous combustion. 3. It should not have high rate of combustion. 4. The pressure drop should be as small as possible
If P + Q implies P - Q P - Q implies P × Q P × Q implies P ÷ Q P ÷ Q implies P + Q Which of the following is TRUE?
If aAb implies a + b, aMb implies a - b, aPb implies a × b and aQb implies a ÷ b, then which of the following equations is correct?