Bissoy.com
Doctors Medicines MCQs Q&A

In a singly reinforced beam

In a singly reinforced beam Correct Answer Plane sections transverse to the centre line of the beam before bending remain plane after bending

Related Questions

Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
Consider the following statements: 1. Functions of reinforcement in reinforced soil and in reinforced concrete are comparable. 2. The design of a geotextile reinforced wall is similar in principle to that of a reinforced earth wall. Which of the above statements is/are correct?
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
In a singly reinforced beam, if the permissible stress in concrete reaches earlier than that in steel, the beam section is called
If d and n are the effective depth and depth of the neutral axis respectively of a singly reinforced beam, the lever arm of the beam, is
A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n?. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is
A singly reinforced beam has breadth b, effective depth d, depth of neutral axis n and critical neutral axis n1. If fc and ft are permissible compressive and tensile stresses, the moment to resistance of the beam, is
In a singly reinforced beam, the effective depth is measured from its compression edge to
Where should you implement the steel reinforcement in a singly reinforced beam?