Related Questions

If a spring is cut down into two springs, the stiffness of cut springs will be
A Half
B Same
C Double
D None of the above
For a plate-modulated class C amplifier the plate supply voltage is E. The maximum plate cathode voltage could be almost high as
A 2E
B 3E
C 4E
D 6E
Introduction of slurry in a plate and frame filter press is done through a plate in each frame. The plate of this filter has a __________ surface.
A Plane
B Curved
C Ribbed
D Either A or B
A high vapour velocity is required for high plate efficiency in a seive plate coloumn. The satisfactory value of operating vapor velocity for design purpose in seive plate column is about __________ percent of the flooding velocity.
A 45
B 60
C 80
D 95
পাত-দূরত্ব d এবং ধারকত্ব C. এমন একটি সমান্তরাল পাত ধারকের পাত দুটির মাঝখানে d/2 পুরুত্ববিশিষ্ট একটি ধাতব পাত স্থাপন করা হলো। নতুন ধারকত্ব কত হবে? (A metal plate of thickness d/2 is inserted between the plates of a parallel plate capacitor with plate separation d and capacitance C. What is the new capacitance?)
A C/d
B C/2
C 4Cd
D 2c
The frictional torque transmitted by a disc or plate clutch is same as that of
A flat pivot bearing
B flat collar bearing
C conical pivot bearing
D trapezoidal pivot bearing
Clutch facings are usually attached to the plate by
A Steel rivets
B Brass rivets
C Aluminium screws
D Steel screws
In a single dry plate clutch, torsional vibrations are absorbed by
A Coil springs known as torsional springs
B Cushion springs
C Central hub
D Clutch pedal
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
A $$\sigma \left( {1 + \frac{{\text{b}}}{{2{\text{a}}}}} \right)$$
B $$\sigma \left( {1 + \frac{{2{\text{a}}}}{{\text{b}}}} \right)$$
C $$\sigma \left( {1 + \frac{{\text{b}}}{{3{\text{a}}}}} \right)$$
D $$\sigma \left( {1 + \frac{{3{\text{a}}}}{{\text{b}}}} \right)$$
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to
A 1 d
B 1.25 d
C 1.5 d
D 1.75 d

Next steps