Bissoy.com
Doctors Medicines MCQs Q&A

For maximum discharge through a chimney, the condition is that height of hot gas column producing the draught should be

For maximum discharge through a chimney, the condition is that height of hot gas column producing the draught should be Correct Answer Equal to the height of chimney

Related Questions

A chimney of height 45 m is full of hot gases at temperature 330°C. If the discharge through the chimney is maximum, determine the draught in terms of column of hot gases. The ambient is 25°C.
Draught produced by a tall chimney due to density difference between hot flue gas inside the Chimney and atmospheric air outside the chimney is more appropriately known as the __________ draught.
The draught (in mm of water), for maximum discharge of flue gases through the chimney, is given by (where H = Height of the chimney in meters and T1 = Absolute temperature of air outside the chimney in K)
Determine the height of the chimney to produce a static draught of 22mm of water if the mean flue gas temperature in chimney is 290oC and ambient temperature in boiler house is 20oC. The gas constant for air is 29.26Kgm/Kgk and for chimney flue gas is 26.2 Kgfm/Kgk. Assume reading as 760mm of mercury?
What is the ratio of draught in terms of column of hot gases to the chimney height when the discharge though chimney is maximum?
The draught produced by the chimney is due to the difference in densities between the column of hot gases inside the chimney and the cold air present outside.
Consider the following Column A and Column B in which the names of microorganisms are given in Column A and the groups to which they belong are given in Column B: Column A Column B (a) Aspergillus (i) Algae (b) Lactobacillus (ii) Bacteria (c) Paramecium (iii) Fungi (d) Spirogyra (iv) Protozoa   (v) Virus The correct match of the items of Column A with that of Column B is
Two centrifugal pumps P and R are available for use in a pipe flow system and their head-discharge characteristics are as follows. Pump P Pump R Discharge (cumecs) Head (m) Discharge (cumecs) Head (m) 0 40 0 45 0.12 35 0.14 40 0.2 28 0.24 35 0.3 18 0.3 28   The following statements (S1, S2, and S3) pertain to the head and discharge values during actual operation. Neglect losses in the system. Which of the following statements are correct? S1: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 35 m. S2: When the two pumps P and R are connected in parallel, the discharge is 0.36 cumecs corresponding to a head of 70 m. S3: When the two pumps P and R are connected in series, the discharge is 0.3 cumecs corresponding to a head of 46 m.
The maximum discharge through a chimney occurs when the height of chimney is
Consider the following statements for Euler’s equation to find the critical load of a column : 1. Critical load of a column is proportional to the flexural rigidity. 2. Critical load of a column depends upon yield stress. 3. Critical load of a column is inversely proportional to the length of the column. 4. Critical load of a column is inversely proportional to the square of the length of the column. Which of the above statements are correct?