Related Questions

Draught produced by a tall chimney due to density difference between hot flue gas inside the Chimney and atmospheric air outside the chimney is more appropriately known as the __________ draught.
A Natural
B Induced
C Forced
D Chimney
For the same draught produced the power of induced draught fan as compared to forced draught fan is
A less
B more
C same
D not predictable
Power required in case of forced draught as compared to induced draught (for the same draught produced) is
A Same
B Less
C More
D Either more or less; depends on the flue gas density
The draught produced, for a given height of the chimney and given mean temperature of chimney gases
A decreases with increase in outside air temperature
B increases with increase in outside air temperature
C remains the same irrespective of outside air temperature
D may increase or decrease with increase in outside air temperature
The air pressure at the fuel bed is reduced below that of atmosphere by means of a fan placed at or near the bottom of the chimney to produce a draught. Such a draught is called
A Natural draught
B Induced draught
C Forced draught
D Balanced draught
The draught produced by chimney of given height at given outside temperature
A decreases if the chimney gas temperature increases
B increases if the chimney gas temperature increases
C remains same irrespective of chimney gas temperature
D may increase or decrease
In a furnace employing forced draught as compared to induced draught,
A Air is sucked in, so air leaks are more and hence the furnace efficiency is reduced
B The fan operates hot and hence blades are liable to corrosion and erosion
C Positive pressure exists in the furnace
D None of these
For maximum discharge through a chimney, the condition is that height of hot gas column producing the draught should be
A One-half the height of chimney
B Equal to the height of chimney
C Two times the height of chimney
D Four times the height of chimney
The solid brick shown is made of small square shaped bricks of side 1. when the large brick is disassembled into its component small bricks. the total surface area of all the small bricks is how much greater than the surface area of the large brick?
A 32
B 40
C 60
D 72
The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as
A Troweling
B Laying
C Grouting
D Placing

Next steps