Related Questions

The maximum discharge through a chimney occurs when the height of chimney is
A Infinitely long
B Around 200 meters
C Equal to the height of the hot gas column producing draught
D Outside temperature is very low
Draught produced by a tall chimney due to density difference between hot flue gas inside the Chimney and atmospheric air outside the chimney is more appropriately known as the __________ draught.
A Natural
B Induced
C Forced
D Chimney
For maximum discharge through a chimney, the condition is that height of hot gas column producing the draught should be
A One-half the height of chimney
B Equal to the height of chimney
C Two times the height of chimney
D Four times the height of chimney
The draught produced by steel chimney as compared to that produced by brick chimney for the same height is
A Less
B More
C Same
D May be more or less
The draught produced, for a given height of the chimney and given mean temperature of chimney gases
A decreases with increase in outside air temperature
B increases with increase in outside air temperature
C remains the same irrespective of outside air temperature
D may increase or decrease with increase in outside air temperature
Flue gas discharge velocity through chimney of a big thermal power plant may be around __________ m/sec.
A 0.5
B 500
C 10
D 50
The discharge over the trapezoidal notch is equal to the discharge over the rectangular notch __________ the discharge over the triangular notch.
A Plus
B Minus
C Divide
D None of these
The discharge through a convergent mouthpiece is __________ the discharge through an internal mouthpiece of the same diameter and head of water.
A Equal to
B One-half
C Three fourth
D Double
The draught produced by chimney of given height at given outside temperature
A decreases if the chimney gas temperature increases
B increases if the chimney gas temperature increases
C remains same irrespective of chimney gas temperature
D may increase or decrease
Stack (chimney) height in a big thermal power plant is dictated by the
A Pollution control aspect
B Draught to be created
C Limitation of constructional facilities
D None of these

Next steps