Related Questions

The variable required to be known in correlations used for estimating the horse power of a centrifugal gas compressor and hence its cost are P. Inlet pressure Q. Compressor rpm R. Delivery pressure S. Volumetric flow rate at inlet.
A P, Q and R
B P and R
C R and S
D P, R and S
In an axial flow compressor, the ratio of pressure in the rotor blades to the pressure rise in the compressor in one stage is known as
A Work factor
B Slip factor
C Degree of reaction
D Pressure coefficient
The minimum work required for a three stage reciprocating air compressor is ________ the work required for each stage.
A Equal to
B Double
C Three times
D Six times
For a two stage compressor, if index of compression for higher stage is greater than index of compression for lower stage, then the optimum pressure as compared to ideal case will
A Increase
B Decrease
C Remain unaffected
D Other factors control it
The primary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given by (where m = Mass of reciprocating parts, $$\omega $$ = Angular speed of crank, r = Radius of crank, $$\theta $$ = Angle of inclination of crank with the line of stroke and n = Ratio of the length of connecting rod to radius of crank)
A $${\text{m}}{\omega ^2}{\text{r}}\sin \theta $$
B $${\text{m}}{\omega ^2}{\text{r}}\cos \theta $$
C $${\text{m}}{\omega ^2}{\text{r}}\frac{{\sin 2\theta }}{{\text{n}}}$$
D $${\text{m}}{\omega ^2}{\text{r}}\frac{{\cos2\theta }}{{\text{n}}}$$
The secondary unbalanced force due to inertia of reciprocating parts in a reciprocating engine is given by (where m = Mass of reciprocating parts, $$\omega $$ = Angular speed of crank, r = Radius of crank, $$\theta $$ = Angle of inclination of crank with the line of stroke and n = Ratio of the length of connecting rod to radius of crank)
A $${\text{m}}{\omega ^2}{\text{r}}\sin \theta $$
B $${\text{m}}{\omega ^2}{\text{r}}\cos \theta $$
C $${\text{m}}{\omega ^2}{\text{r}}\frac{{\sin 2\theta }}{{\text{n}}}$$
D $${\text{m}}{\omega ^2}{\text{r}}\frac{{\cos2\theta }}{{\text{n}}}$$
In a single acting reciprocating compressor, the suction, compression and delivery of air takes place in ________ of the piston.
A One stroke
B Two strokes
C Three strokes
D Four strokes
In a single stage, single acting reciprocating air compressor without clearance volume, the work-done is maximum during
A Isothermal compression
B Isentropic compression
C Polytropic compression
D None of these
In a single stage, single acting reciprocating air compressor, without clearance volume, the work-done is minimum during
A Isothermal compression
B Isentropic compression
C Polytropic compression
D None of these
In a high pressure compressor, the delivery pressure is
A 1 to 5 bar
B 5 to 8 bar
C 8 to 10 bar
D 10 to 15 bar

Next steps