Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Consider the following statements regarding stress in beam : 1. If a member is subjected to equal and opposite couples acting in the same longitudinal planes, the member is said to be in pure bending. 2. The internal stresses developed in the beam are known as flexural stresses. 3. There is an intermediate surface known as neutral surface, at which the stress is zero. 4. An axis obtained by intersection of the neutral surface and a cross-section is known as neutral axis. Which of the above statements are correct ? 
In which of the following cases, there exists the situation of Pure Bending in some part of the beam or along the entire beam? i) A simply supported beam subjected to two equally spaced downward concentrated loads ii) A simply supported beam subjected to two equally spaced opposite moments iii) A cantilever beam subjected to clockwise moment at free end iv) An overhanging beam with both side overhangs subjected to different concentrated loads at both the free ends
If for a curved beam of trapezoidal cross section, radius of neutral axis is 89.1816mm and radius of centroidal axis is 100mm, then find the bending stress at inner fibre whose radius is 50mm. Area of cross section of beam is 7200mm² and the beam is loaded with 100kN of load.
Consider the following statements: The basic reason why shafts are made of steel and its alloys is: 1. The shaft is subjected to normal stress. 2. The shaft stress alternates with respect to time. 3. The shaft is subjected to pure compressive stress. 4. The shaft is subjected to the stress of constant intensity. Which of these statements are correct?
Consider the following statements with regards to the shear force diagram for the beam ABCD: 1. The beam ABCD is an overhanging beam having supports at A and D only. 2. The beam carries a point load of 20 kN at C. 3. The beam carries a concentrated load of 10 kN at the end B. 4. The beam is an overhanging beam having supports at C and D only. 5. The beam carries a uniformly distributed load of 70 kN over the left hand portion AC only. Which of the above statements are correct?
When a beam is subjected to bending moment, the stress at any point is __________ the distance of the point from the neutral axis.
consider a simply supported beam with a uniformly distributed load having a neutral axis (NA) as shown. For points P (on the neutral axis) and Q (at the bottom of the beam) the state of stress is best represented by which of the following pairs?
Consider the following statements regarding types of supports and beams: 1. When both supports of beams are roller supports, the beam is known as simply supported beam. 2. A beam with one end fixed and the other end free is known as fixed beam. 3. A beam with both ends fixed is known as cantilever beam. 4. A beam with one end fixed and the other simply supported is known as propped cantilever. Which of the above statements is/are correct ?
If the depth of actual neutral axis in a beam is more than the depth of critical neutral axis, then the beam is called
When the depth of the actual neutral axis in a beam is greater than the depth of the critical neutral axis, then the beam is called: