Related Questions

In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then it will be necessary to
A Increase the key length
B Increase the key depth
C Increase the key width
D Decrease the key length
For same pulley diameters, center distance, belt speed and belt and pulley materials,
A Open belt drive transmits more power than crossed belt drive
B Crossed belt drive transmits more power than open belt drive
C Open and crossed belt drives transmit same power
D Power transmission does not depend upon open and crossed types of constructions
A pulley and belt in a belt drive form a
A Cylindrical pair
B Turning pair
C Rolling pair
D Sliding pair
When the belt is stationary, it is subjected to some tension known as initial tension. The value of this tension is equal to the
A tension in the tight side of the belt
B tension in the slack side of the belt
C sum of the tensions on the tight side and slack side of the belt
D average tension of the tight side and slack side of the belt
The power transmitted by a belt is maximum when the maximum tension in the belt is _________ of centrifugal tension.
A One-third
B Two-third
C Double
D Three times
The tension on the slack side of the belt is __________ the tension on the tight side of the belt.
A Equal to
B Less than
C Greater than
D None of these
The width of the pulley should be __________ width of the belt.
A Equal to
B Less than
C Greater than
D None of these
You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
A as a master
B as a secondary
C as a slave
D as a primary
E as auto-select
When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be
A 0.8 d
B 1.2 d
C 1.57 d
D 1.8 d
Pulley in a belt drive acts as
A cylindrical pair
B turning pair
C rolling pair
D sliding pair

Next steps