Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The interference between a given pinion tooth and a gear tooth can be avoided by using 1. smaller pressure angle 2. larger pressure angle 3. Less number of teeth on the gear for a pinion with predefined number of teeth 4. More number of teeth on the gear for a pinion with predefined number of teeth Which of the above statements are correct?
The minimum number of teeth on the pinion which will mesh with any gear without interference for 200 full depth involute teeth will be
The velocity ratio between pinion and gear in a gear drive is 2.3, the module of teeth is 2.0 mm and sum of number of teeth on pinion and gear is 99. What is the centre distance between pinion and the gear?
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. A pair of spur gears consist of 25 teeth pinion meshing with a 115 teeth gear. The module is 5mm. Calculate the gear ratio.
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear C if number of teeth on gear A, B and C are 40, 70 and 30.
Twenty degree full depth involute profiled 19-tooth pinion and 37-tooth gear are in mesh. If the module is 5 mm, the centre distance between the gear pair will be
In full depth involute system, the smallest number of teeth in a pinion which meshes with rack without interference is
In full depth 140 involute system, the smallest number of teeth in a pinion which meshes with rack without interference is
A fixed gear having 200 teeth is in mesh with another gear having 50 teeth. The two gears are connected by an arm. The number of turns made by the smaller gear for one revolution of arm about the centre of bigger gear is
Two involute gears in a mesh have path of approach = 29.83 mm and path of recess = 21.09 mm. The larger gear has 40 teeth and the pinion has 12 teeth. Find the ratio of the sliding to rolling velocity at the: i) beginning of contact ii) end of contact iii) pitch point r = 72 mm