Related Questions

The strap end of a connecting rod of steam engine is joined by
A Gib of cotter joint
B Sleeve and cotter joint
C Spigot socket cotter joint
D Knuckle joint
A cotter joint is used to connect two __________ rods.
A Co-axial
B Perpendicular
C Parallel
D None of these
A double strap butt joint (with equal straps) is
A Always in single shear
B Always in double shear
C Either in single shear or double shear
D Any one of these
A single strap butt joint is always in __________ shear.
A Single
B Double
C Triple share
D None of these
A double strap butt joint with equal straps is
A Always in single shear
B Always in double shear
C Either in single shear or double shear
D None of these
The connecting rod lower end is connected to the relevant ________ of crankshaft.
A Big end
B Crank arm
C Journal
D Small end
The draw of cotter should not be more than
A 3 mm
B 6 mm
C 8 mm
D 12 mm
Taper on the cotter and slot is provided
A On both the sides
B On one side only
C On none of the sides
D May be provided anywhere
Taper usually provided on cotter is
A 1 in 5
B 1 in 10
C 1 in 24
D 1 in 40
The taper on cotter varies from
A 1 in 24 to 1 in 20
B 1 in 15 to 1 in 10
C 1 in 32 to 1 in 24
D 1 in 48 to 1 in 24

Next steps