Related Questions

Taper on the cotter and slot is provided
A On both the sides
B On one side only
C On none of the sides
D May be provided anywhere
Taper usually provided on cotter is
A 1 in 5
B 1 in 10
C 1 in 24
D 1 in 40
In standard taper roller bearings, the angle of taper of outer raceway is
A 5°
B 8°
C 15°
D 25°
A cotter joint is used to connect two __________ rods.
A Co-axial
B Perpendicular
C Parallel
D None of these
The draw of cotter should not be more than
A 3 mm
B 6 mm
C 8 mm
D 12 mm
Which of the following cotter joint will be used to connect strap end of a connecting rod?
A Spigot and socket cotter joint
B Sleeve and cotter joint
C Gib and cotter joint
D Any one of these
The draw of cotter need not exceed
A 3 mm
B 5 mm
C 10 mm
D 20 mm
If A varies directly proportional to C and B also varies directly proportional to C, which one of the following is not correct ?
A $$\left( {A + B} \right)\alpha \,C$$
B $$\left( {A - B} \right)\alpha \,\frac{1}{C}$$
C $$\sqrt {AB} \,\alpha \,C$$
D $$\frac{A}{B} = {\text{constant}}$$
The tail stock set over method of taper turning is preferred for
A internal tapers
B small tapers
C long slender tapers
D steep tapers
The angle of taper on draft tube is
A Greater than 15°
B Greater than 8°
C Greater than 5°
D Less than 8°

Next steps