Related Questions

Taper on the cotter and slot is provided
A On both the sides
B On one side only
C On none of the sides
D May be provided anywhere
The taper on cotter varies from
A 1 in 24 to 1 in 20
B 1 in 15 to 1 in 10
C 1 in 32 to 1 in 24
D 1 in 48 to 1 in 24
In standard taper roller bearings, the angle of taper of outer raceway is
A 5°
B 8°
C 15°
D 25°
A cotter joint is used to connect two __________ rods.
A Co-axial
B Perpendicular
C Parallel
D None of these
The draw of cotter should not be more than
A 3 mm
B 6 mm
C 8 mm
D 12 mm
Which of the following cotter joint will be used to connect strap end of a connecting rod?
A Spigot and socket cotter joint
B Sleeve and cotter joint
C Gib and cotter joint
D Any one of these
The draw of cotter need not exceed
A 3 mm
B 5 mm
C 10 mm
D 20 mm
The drill spindles are provided with standard taper known as
A Morse taper
B Seller's taper
C Chapman taper
D Brown and Sharpe taper
The lathe centres are provided with standard taper known as
A Morse taper
B Seller's taper
C Chapman taper
D Brown and Sharpe taper
A taper provided on the pattern for its easy and clean withdrawal from the mould is known as
A Machining allowance
B Draft allowance
C Shrinkage allowance
D Distortion allowance

Next steps