Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

The Transfer characteristic of the different types of MOSFETs is shown below, where ID is drain current and VGS is the Gate-Source voltage, the correct combination of MOSFET w.r.t to transfer characteristics is: Types of MOSFET (P) P – Channel Enhancement MOSFET (Q) P – Channel Depletion MOSFET (R) N – Channel Enhancement MOSFET (S) N – Channel Depletion MOSFET
Choose the correct statement(s) i) The gate circuit impedance of MOSFET is higher than that of a BJT ii) The gate circuit impedance of MOSFET is lower than that of a BJT iii) The MOSFET has higher switching losses than that of a BJT iv) The MOSFET has lower switching losses than that of a BJT
Why is an N-channel MOSFET preferred over a P-channel MOSFET?
The N-channel MOSFET is considered better than the P-channel MOSFET due to its
Statement (I): An alluvial channel is defined as a channel in which the flow transports sediment of the same physical characteristic as the material in the wetted surface of the channel. Statement (II): This ensures that the channel cross-section and the channel slope do not change.
The Secure Shell Connection Protocol Message exchange has the fist phase as “Opening a Channel” and it sends a message with parameters- SSH_MSG_CHANNEL_OPEN channel type sender channel innitial window size maximum packet size What is the data type sender channel/innitial window size/ channel type?
Group I shows different heat addition processes in power cycles. Likewise, Group II shows different heat removal processes. Group III lists power cycles. Match items from Groups I, II and III. Group I Group II Group III P. Pressure constant S. Pressure constant 1. Rankine cycle Q. Volume constant T. Volume constant 2. Otto cycle R. Temperature constant U. Temperature constant 3. Carnot cycle     4. Diesel cycle     5. Brayton cycle
Which of the following statement/s about MOSFET is correct? (I) In the P-type device current flows due to electrons. (II) In depletion type of MOSFET channel is already present. (III) Pinch-off occurs at VDS < VGS − VTH
The discharge through a trapezoidal channel is 61 m3/s and the depth and widths of the channel are 4m and 5m respectively. The wetted perimeter of the channel is 13.16m, calculate the bed slope of the channel if the value of C is 45.
Calculate the corresponding hydraulic mean depth that would exist in the channel if the bed was unrippled. The rugosity coefficient in an unrippled channel is 0.015 and the rugosity coefficient actually observed by experiments on the rippled bed of channel is 0.020. Consider the value of hydraulic mean depth of the channel as 1.5 m.