Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Which of the following sequence of Heat zones is/are correctly placed? A) Torrid zone, South temperate zone and Frigid zone. B) Torrid zone, North temperate zone and Frigid zone. C) South temperate zone, torrid zone and Frigid zone. Select the correct answer given below.
A fillet-welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets are of 10 mm size and the weld length is 30 mm. If the allowable shear stress of the weld is 94 MPa, considering the minimum throat area of the weld, the maximum allowable transverse load per weld in kN is
In the consumable electrode shielded metal arc welding process, which of the following observations are correct?
P. The, weld composition does not depend upon the basicity of the slag.
Q. Basic flux is used to achieve low hydrogen content-and low inclusion content in the weld metal.
R. Reverse polarity of the direct current power source is used to weld thin sheets.
S. Coated electrodes are classified by tensile strength of the weld metal deposit.
The largest size of immobilised segment of dislocation in a Frank Read (FR) source contained in a polycrystalline material is of the order of grain size. In a metal of 10 μm grain size, the shear stress required to operate such a FR source is 100 MPa. If the grain size in the same metal is reduced to 10 μm, the shear stress required to operate such FR source would be . . . . . . . . MPa.
Kamala has three cylindrical containers, each with radius 20 cm that she wants to fill with grain. If her bag of grain contains 100 kg of grain, and she fills all three containers to a height of 70 cm, how much grain will be left in the bag, if 1 kg grain occupies 3000 cm3 space? (Use π = \(\frac{{22}}{7}\))
In order to double its yield strength, the grain size of a steel of ASTM grain size number 2 should be changed to ASTM grain size number (neglect friction stress)
The tensile strength of the welded joint for double fillet is (where s = Leg or size of the weld, $$l$$ = Length of weld and $${\sigma _{\text{t}}}$$ = Allowable tensile stress for weld metal)
Which of the following characteristics should be possessed by a properly made weld? 1. The weld should not crack in the bend test 2. There should be no scum imbedded In the weld 3. Appearance should be spongy 4. Electrode distance variation should be minimal
Two plates of 12mm and 16mm thickness are to be joined by groove weld. The joint is subjected to factored tensile load of 400kN. Due to some reasons the effective length of weld that could be provided was 150mm only. What is the safety of joint if single-V groove weld is provided?
In butt weld joint, what will be the strength equation? if the thickness of the plate is t, permissible tensile stress for the weld is σt, and the length of the weld is l.