Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In IC engine 1. the ideal air capacity of a two-stroke engine is the mass of air required to concurrently fill the total cylinder volume at inlet temperature and exhaust pressure 2. with increase in air-fuel ratio beyond the value for maximum power, there is a fall in power developed and this fall is more with higher values of air-fuel ratio. 3. the volumetric efficiency of the engine depends on the design of intake and exhaust manifold. Which of the above are correct?
In MPFI-Air Induction System, the air cleaner, the air flow meter, the throttle body and the air valve supply a proper amount of air to the air intake chamber and intake manifold.
In the port injection arrangement, the injector is placed on the side of the intake manifold near the intake port.
In an electronic fuel injection system, the ECU calculates the optimum fuel injection volume for the current engine condition based on data from a wide range of sensor, and it injects this volume of fuel into the intake manifold at the optimum timing.
A solid-oxide fuel cell is fed with carbon monoxide and reacts with air to produce CO2. This reaction will produce 2 electrons which are used to power an electric circuit external to the fuel cell. The reaction equation is shown below: 2CO(g) + O2(g) -> 2CO2(g) ΔHr° = -565.96 kJ/mol This reaction does not occur for other types of fuel cells which use a catalyst, such as polymerelectrolyte membrane or phosphoric-acid fuel cells. The presence of carbon monoxide on the anode side of these types of fuel cells will cause catalyst poisoning, reducing the efficiency and voltage of the fuel cell. Determine the rate of enthalpy change for a carbon dioxide production rate of 208 mol/hr. The extent of the reaction occurring in the fuel cell can be obtained by the following equation: where:
Which among the following options represents the correctly matched pair of the name of the sea-port and their state? Name of the port State A. Jawaharlal Nehru Port 1. Tamil Nadu B. Paradip Port 2. Maharashtra C. Kandla Port 3. Odisha D. Ennore Port 4. Gujarat
oil and kerosene are present in ratio of 5 : 7 in a liquid. Few litres of mixture of mixture are replaced with petrol. Ratio of oil : kerosene: petrol is 35 : 49 : 18 respectively. Amount of oil removed from mixture is 21 litres less than that of petrol added to the mixture. And amount of oil removed is 6 litres less than that of difference mentioned. Petrol is replacing the mixture removed hence; quantity of mixture is not changing. What is the difference between quantity of kerosene in old mixture and amount of oil in new mixture?
In a diesel engine
1. Fuel injection pump is used
2. Fuel injection pump and carburettor is used
3. Fuel injector is used
4. Neither fuel injection pump nor injector is used
Which one of the statement is correct?
1. Petrol engine is a reciprocating engine
2. Petrol engine is high speed engine
3. Petrol engine uses petrol as fuel
4. Petrol engine is internal combustion engine
In order to burn a fuel completely, which of the following basic conditions must be fulfilled? 1. Supply enough air for complete combustion of fuel. 2. Secure low turbulence for thorough mixing of fuel and air. 3. Maintain a furnace temperature high enough to ignite the incoming fuel air mixture. 4. Provide a furnace volume large enough to allow time for combustion to be completed. Select the correct answer using the code given below: