Related Questions

The exhaust throttling loss occurs due to the restrictions imposed by air cleaner, carburetor venturi, throttle valve, intake manifold and intake valve.
X hands over her expensive saree for cleaning to a dry cleaner who loses the same. X claims the total value of the saree. The dry cleaner refers to a clause printed in the contract receipt which states that the dry cleaner can be held liable for Rs. 50 or 10% of the original value of the cloth only, whichever is less. Which one of the following propositions holds good to explain the correct position of law on the point?
Which of the following heart valves are mechanical valves? i. Ball Valve ii. Autograft Valve iii. Xenograft Valve iv. Single Leaflet Valve v. Homograft Valve vi. Bi leaflet Valves
In MPFI-Fuel system, the throttle receives signals from the ECU and inject the fuel into the intake manifold.
The electronic control throttle system operates the throttle valve by
Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow and k = Thermal conductivity of the body)
The intake manifold is a . . . . . . . . tube for carrying the air fuel mixture from the carburettor to the engine intake port.
In the port injection arrangement, the injector is placed on the side of the intake manifold near the intake port.
A 2" gate valve fitted in a pipe is replaced by a similar globe valve. Pressure drop in gate valve was Δp. For the same discharge, the pressure drop across globe valve is
The flow capacity of a valve is calculated by the _________ Cv, the flow of water through a wide—open valve in U.S. gal/min for a pressure gradient of 1 psi. For a given nominal valve size the highest Cv is achieved with ball valves followed by (in decreasing order) gate, plug, and globe valves.