Related Questions

The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. Which of the following, if given to the mixing vat operator as an instruction, would not determine the setting of any other valve ?
A S must be open
B T must be open
C U must be open
The ratio of momentum diffusivity to thermal diffusivity is the __________ number.
A Prandtl
B Nusselt
C Stanton
D Grashoff
If the catalyst pore size is small in comparison with the mean free path, collisions with the pore wall controls the process'. The diffusivity under this condition is called 'Knudsen diffusivity', which is affected by the
A Pressure
B Temperature
C Both A & B
D Neither A nor B
If mass diffusivity in a mixture is equal to the thermal diffusivity, then the Lewis number is
A 0
B 1
C > 1
A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be
A $$\frac{\tau }{2}$$
B $$\tau $$
C $$2\tau $$
D $$4\tau $$
Mixing mechanism employed in a pan mixer is by
A Mulling
B Kneading
C Dispersion
D None of these
By mixing two qualities of pulses in the ration 2:3 and selling the mixture at the rate of Tk. 22 per kilogram, a shopkeepers makes a profit of 10%. If the cost of the smaller quantity be TK. 14 per kg the cost in Tk per kg of the larger quantity is:
A 23
B 24
C 25
D 26
If an ideal solution is formed by mixing two pure liquids in any proportion, then the __________ of mixing is zero.
A Enthalpy
B Volume
C Both A & B
D Neither A nor B
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
A $$\frac{{{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
B $$\frac{{2{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
C $$\frac{{4{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
D $$\frac{{8{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
In a counter-current extractor, as the axial mixing increases, the extraction efficiency
A Increases
B Decreases
C Remains unchanged
D Depends on the pressure of the system

Next steps