Related Questions

The mixing vat in a factory receives liquid ingredients through six separate value--- labeled R.S.T.U,Y and Z -- each of which has exactly two settings: open and closed.The mixing vat operator must ensure that each valve is set open or closed according to the following conditions: If T is open, both S and Z must be closed, R and Z cannot both be closed at the same time; If Y is closed, Z must also be closed;S and U cannot both be open at the same time. Which of the following, if given to the mixing vat operator as an instruction, would not determine the setting of any other valve ?
A S must be open
B T must be open
C U must be open
__________ extractor is used for the concentration of radioactive nuclear waste.
A Pulsed column
B Seive plate
C Mixer-settler
D Ballman
Bollman extractor
A Is a static bed leaching equipment
B Is used for extraction of oil from oilseed
C Is a centrifugal extractor
D Employs only counter-current extraction
__________ extractor uses centrifugal force for separating the two phases.
A Treybal
B Schiebel
C Podbielniak
D None of these
In a counter-current liquid extractor
A Both liquids flow at fixed rate
B Both liquids can have any desired flow rate
C Only one of the liquids may be pumped at any desired rate
D Liquid's flow rate depends upon the temperature and pressure
Slope of countercurrent flow rotary drier is in the range of __________ meter/metre.
A 0 to 0.08
B 0 to 0.8
C 0 to 1.5
D 0 to 2.2
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
A $$\frac{{{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
B $$\frac{{2{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
C $$\frac{{4{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
D $$\frac{{8{\text{WD}}}}{{\pi {{\text{d}}^3}}} \times {\text{K}}$$
A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be
A $$\frac{\tau }{2}$$
B $$\tau $$
C $$2\tau $$
D $$4\tau $$
In a mixer, the quantity, (v. L/D) is termed as __________ number(where, v = longitudinal velocity of material, L = length of the mixer, D = diffusivity in axial mixing).
A Weber
B Peclet
C Brinkman
D Schmidt
Solvent extraction is the terminology applied to the liquid-liquid extraction, which is preferred for the separation of the components of liquids, when
A Extracting solvent is cheaply & abundantly available
B One of the liquid components is heat sensitive
C Viscosity of liquid components is very high
D One of the liquid components has very high affinity towards the solvent

Next steps