Related Questions

Point A is 10 miles West of Point B. Point b is 30 miles North of pint C. Point C is 20 miles East of Point D. What is the distance (in miles) between Point A and Point D?
A 1010
B 1020
C 2010
D 3010
Point A is 10 km west of point B. Point B is 30 km north of point C. Point C is 20 km east of point D. What is the distance between point A and D?
A 1020Km
B 1010Km
C 2010Km
D 3010Km
In class A operation, the operating point is generally located ___________ of the d.c. load line.
A At cut off point
B At the middle
C At saturation point
D None of the above
For proper amplification by a transistor circuit, the operating point should be located at the ___________ of the d.c. load line
A The end point
B Middle
C The maximum current point
D None of the above
Point A is south of point B and point B is west point C. To which direction is point A with respect to point C ?
A South
B South West
C North east
D North West
Point A is 10 miles west of Point B. Point B is 30 miles North of Point C. Point C is 20 miles East of Point D. what is the distance between points A and D?
A 1010
B 810
C 710
D 910
The slope of a.c. load line is ___________ that of d.c. load line
A The same as
B More than
C Less than
D None of the above
When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)
A Is at the maximum distance from CG of the rivet group
B Is at the minimum distance from CG of the rivet group
C Gives the maximum angle between the two forces Fa and Fm
D Gives the minimum angle between the two forces Fa and Fm
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm
The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is
A $$\frac{5}{8}$$
B $$\frac{8}{5}$$
C $$\frac{5}{4}$$
D $$\frac{4}{5}$$

Next steps