Related Questions

For faithful amplification by a transistor circuit, the value of VBE should ___________ for a silicon transistor
A Be zero
B Be 0.01 V
C Not fall below 0.7 V
D Be between 0 V and 0.1 V
For faithful amplification by a transistor circuit, the value of VCE should ___________ for silicon transistor
A Not fall below 1 V
B Be zero
C Be 0.2 V
D None of the above
In a single stage transistor amplifier, RC and RL represent collector resistance and load resistance respectively. The transistor sees a d.c. load of ___________
A RC + RL
B RC || RL
C RL
D RC
For germanium transistor amplifier, VCE should ___________ for faithful amplification
A Be zero
B Be 0.2 V
C Not fall below 0.7 V
D None of the above
In class A operation, the operating point is generally located ___________ of the d.c. load line.
A At cut off point
B At the middle
C At saturation point
D None of the above
Point A is 10 miles West of Point B. Point b is 30 miles North of pint C. Point C is 20 miles East of Point D. What is the distance (in miles) between Point A and Point D?
A 1010
B 1020
C 2010
D 3010
Point A is 10 km west of point B. Point B is 30 km north of point C. Point C is 20 km east of point D. What is the distance between point A and D?
A 1020Km
B 1010Km
C 2010Km
D 3010Km
The value of collector load RC in a transistor amplifier is ___________ the output impedance of the transistor.
A The same as
B Less than
C More than
D None of the above
সাধারণ পীঠ বিন্যাসে একটি ট্রানজিস্টরের সংগ্রাহক প্রবাহ 19.8 mA এবং পীঠ প্রবাহ 0.2 mA হলে প্রবাহ বিবর্ধন গুণক কত? (What is the current amplification factor for a common base configuration of a transistor if its collector current is 19.8 mA and base current is 0.2 mA ? )
A 0.99
B 9.9
C 49 (D)
In testing a pile by load test, pile platform is loaded with one and half times the design load and a maximum settlement is noted. The load is gradually removed and the consequent rebound is measured. For a safe pile, the net settlement (i.e. total settlement minus rebound) per tonne of test load should not exceed
A 10 mm
B 15 mm
C 20 mm
D 25 mm

Next steps