Related Questions

The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as
A Troweling
B Laying
C Grouting
D Placing
The solid brick shown is made of small square shaped bricks of side 1. when the large brick is disassembled into its component small bricks. the total surface area of all the small bricks is how much greater than the surface area of the large brick?
A 32
B 40
C 60
D 72
The nominal thickness of an expansion joint in brick walls, is kept more than
A 5 mm
B 10 mm
C 15 mm
D 20 mm
A ladder is resting against a vertical wall and its bottom is 2.5 m away from the wall. If it slips 0.8 m down the wall, then its bottom will move away from the wall by 1.4 m. What is the length of the ladder?
A 6.2 m
B 6.5 m
C 6.8 m
D \7.5 m
The nominal thickness of one brick wall in mm, is
A 90 mm
B 150 mm
C 190 mm
D 200 mm
The stretcher bond in brick masonry can be used only when the thickness of wall is
A 90 mm
B 180 mm
C 190 mm
D 280 mm
The thickness of a reinforced brick partition wall, is generally kept
A 5 cm
B 10 cm
C 15 cm
D 20 cm
A motorcycle stunt man belonging to a fair rides over the vertical walls of a circular wall at an average speed of 54 km/h for 5 minutes. If the radius of the wall is 5 meters then the distance traveled is ----
A 2.5 km
B 3.5 km
C 5 km
D 4.5 km
In long and short wall method of estimation, the length of long wall is the centre to centre distance between the walls and
A Breadth of the wall
B Half breadth of wall on each side
C One fourth breadth of wall on each side
D None of these
The piece of a brick cut along the centre of width in such a way that its length is equal to that of full brick, is called
A Half brick
B Queen closer
C King closer
D Bevelled closer

Next steps