Related Questions

The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as
A Troweling
B Laying
C Grouting
D Placing
The solid brick shown is made of small square shaped bricks of side 1. when the large brick is disassembled into its component small bricks. the total surface area of all the small bricks is how much greater than the surface area of the large brick?
A 32
B 40
C 60
D 72
The nominal thickness of an expansion joint in brick walls, is kept more than
A 5 mm
B 10 mm
C 15 mm
D 20 mm
A ladder is resting against a vertical wall and its bottom is 2.5 m away from the wall. If it slips 0.8 m down the wall, then its bottom will move away from the wall by 1.4 m. What is the length of the ladder?
A 6.2 m
B 6.5 m
C 6.8 m
D \7.5 m
What is the ratio of displacement thickness to nominal thickness for a linear distribution of velocity in the boundary layer on a flat plate?
A 0.5
B 1
C 1.5
D 2
The pipe wall thickness is minimum for a pipe of given nominal size having schedule number
A 160
B 120
C 80
D 40
The stretcher bond in brick masonry can be used only when the thickness of wall is
A 90 mm
B 180 mm
C 190 mm
D 280 mm
Brick walls are measured in sq. m if the thickness of the wall is
A 10 cm
B 15 cm
C 20 cm
D None of these
The thickness of a reinforced brick partition wall, is generally kept
A 5 cm
B 10 cm
C 15 cm
D 20 cm
The piece of a brick cut with its one corner equivalent to half the length and half the width of a full brick, is known as
A Queen closer
B Bevelled closer
C King closer
D Half king closer

Next steps