Related Questions

The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is _________ cutting speed for drilling mild steel with high speed steel drills.
A Equal to
B Less than
C More than
D None of these
High speed steel cutting tools operate at cutting speeds _________ than carbon steel tools.
A 2 to 3 times lower
B 2 to 3 times higher
C 5 to 8 times higher
D 8 to 20 times higher
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to
A 1 d
B 1.25 d
C 1.5 d
D 1.75 d
To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to
A 0.5 d
B D
C 1.5 d
D 2.5 d
In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)
A 1 d
B 1.5 d
C 2.5 d
D 2 d
In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)
A d
B 1.5 d
C 2 d
D 2.5 d
A tailor had a number of shirt pieces to cut from some large pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute . How many large pieces would be cut in 24 minutes?
A 32
B 54
C 108
D 120
A tailor had a number of shirt pieces to cut from large piece pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute. How many large pieces would be cut in 24 minutes?
A 32
B 54
C 108
D 120
A tailor had a number of shirt pieces to cut from a roll of fabric. He cut each roll of equal length into 10 pieces. He cut at the rate of 45 cuts a minute. How many rolls would be cut in 24 minutes ?
A 32 rolls
B 54 rolls
C 108 rolls
D 120 rolls
In oblique cutting system, the cutting edge of the tool
A May clear the width of the workpiece
B May or may not clear the width of the workpiece
C May not clear the width of the workpiece
D Should always clear the width of the workpiece

Next steps