Related Questions

You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
A as a master
B as a secondary
C as a slave
D as a primary
E as auto-select
When the belt is transmitting maximum power,
A The tension in tight side is twice the centrifugal tension
B The tension in slack side is equal to the centrifugal tension
C The tension in tight side is thrice the centrifugal tension
D None of the above
The power transmitted by a belt is maximum when the maximum tension in the belt is _________ of centrifugal tension.
A One-third
B Two-third
C Double
D Three times
A chain drive transmits __________ power as compared to belt drive.
A More
B Less
C Same
D None of these
A pulley and belt in a belt drive form a
A Cylindrical pair
B Turning pair
C Rolling pair
D Sliding pair
In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set to
A Reduce vibration
B Reduce slip
C Ensure uniform loading
D Ensure proper alignment
In a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set in order to
A Reduce vibration
B Reduce slip
C Ensure uniform loading
D Ensure proper alignment
In V-belt drive, belt touches
A At bottom
B At sides only
C Both at bottom and sides
D Could touch anywhere
In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant, then it will be necessary to
A Increase the key length
B Increase the key depth
C Increase the key width
D Decrease the key length
In a belt drive, the pulley diameter is doubled, the belt tension and pulley width remaining same. The changes required in key will be
A Increase key length
B Increase key depth
C Increase key width
D Double all the dimensions

Next steps