Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.
2. The VTP management domain name of both switches must be set the same.
3. All ports on both the switches must be set as access ports.
4. One of the two switches must be configured as a VTP server.
5. A rollover cable is required to connect the two switches together.
6. A router must be used to forward VTP traffic between VLANs.
A 3 - ϕ CSI used for the speed control of an induction motor is to be realized using MOSFET switches as shown below. Switches S1 to S6 are identical switches. The proper configuration for realizing switches S1 to S6 is
In BiCMOS, MOS switches are used to __________
The two basic technologies for digital ICs are bipolar and MOS. Bipolar technology is preferred for_____ and _____ whereas MOS technology is better suited to LSI.
MoS of Union MHA Ministry has informed Parliament that a proposal to rename West Bengal as Bangla has been received.  Who is the MoS of the Union MHA Ministry?
The figure shows the band diagram of a Metal Oxide Semiconductor (MOS). The surface region of this MOS is in
The depletion mode n-MOS differs from enhancement mode n-MOS in:
The n-MOS invertor consists of n-MOS transistor as driven and
If the n-MOS and p-MOS of the CMOS inverters are interchanged the output is measured at:
What will be the effect on output voltage if the positions of n-MOS and p-MOS in CMOS inverter circuit are exchanged?