Bissoy.com
Doctors Medicines MCQs Q&A

A signal having uniformly distributed amplitude in the interval (-V to + V), is to be encoded using PCM with uniform quantization. The signal to quantizing noise ratio is determined by the

A signal having uniformly distributed amplitude in the interval (-V to + V), is to be encoded using PCM with uniform quantization. The signal to quantizing noise ratio is determined by the Correct Answer Number of quantizing levels

Related Questions

Which of the following statements are true in the case of Pulse Code Modulation (PCM)? a) If the number of bits per sample is increased from n to n + 1; the S/Nq the ratio would be 6 dB b) The quantization noise depends on the sampling rate c) The main advantage of PCM is that it possesses better performance in the presence of noise d) If the number of quantization levels increases from 4 to 64, the bandwidth increase by a factor of 4
A speech signal has a total duration of 20 sec. It is sampled at the rate of 8 kHz and then PCM encoded. The signal-to-quantization noise ratio is required to be 40 dB. The minimum storage capacity needed to accommodate this signal is
Companding is used in PCM transmitters to overcome quantizing noise in PCM.
Mean Value theorem is applicable to the and continuous in open interval (a, b) b) Functions continuous in closed interval only and having same value at point ‘a’ and ‘b’ c) Functions continuous in closed interval and differentiable in open interval (a, b) d) Functions differentiable in open interval (a, b) only and having same value at point ‘a’ and ‘b’
In a PCM system with uniform quantization, increasing the number of bits from 8 to 9 will reduce the quantization noise power by a factor of
Rolle’s theorem is applicable to the and continuous in open interval (a, b) only and having same value at point ‘a’ and ‘b’ b) Functions continuous in closed interval only and having same value at point ‘a’ and ‘b’ c) Functions continuous in closed interval and differentiable in open interval (a, b) only and having same value at point ‘a’ and ‘b’ d) Monotonically Increasing funtions
A sinusoidal massage signal m(t) is transmitted by binary PCM without compression. If the signal to-quantization-noise ratio is required to be at least 48 dB, the minimum number of bits per sample will be
In non uniform quantization, the quantization noise is _______ to signal size.
Which of the following are the basic differences between vibration signature and noise signature? 1. Vibration signature is essentially in the frequency range zero to 100 cps whereas noise signature is in the range 20 cps to 3000 cps. 2. Vibration signature has well-defined peaks whereas the noise signal is smeared. 3. The intensities of noise signatures arc much less than that of vibration signatures. 4. Detection of vibration signature calls for a microphone whereas that of noise can do with a pickup. Select the correct answer using the code given below.
A sinusoidal signal with peak-to-peak amplitude of 1.536 V is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is