Related Questions

You are about to install a second IDE hard drive in a PC that has only one IDE adapter. Your first hard drive will still be the boot drive. How should the second drive be configured?
A as a master
B as a secondary
C as a slave
D as a primary
E as auto-select
Six arms negotiators -- M,O,P,R,S and T-- are to be seated at a round table to discuss disarmament. There are exactly six chairs around the table. Each negotiator sits facing the center of the table and is directly opposite a negotiators across the table.The seating arrangement is subject to the following restrictions : T cannot sit next to P;S cannot sit next to M;R must sit next to M. If T sits next to M and S sits next to R, which of the other negotiators must sit next to s ?
A M
B O
C P
D R
When configuring a new network interface card for installation, which of the following would be a valid I/O address?
A 378
B 2F8
C 3F8
D 360
E None of the above
Six arms negotiators -- M,O,P,R,S and T-- are to be seated at a round table to discuss disarmament. There are exactly six chairs around the table. Each negotiator sits facing the center of the table and is directly opposite a negotiators across the table.The seating arrangement is subject to the following restrictions : T cannot sit next to P;S cannot sit next to M;R must sit next to M. If M sits next to P which of the following is a complete and accurate list of those who can sit next to P on P's other side ?
A O
B O,S
C O,S,R
D R,S,T
You just installed a new IDE hard drive, but your system BIOS will not recognize the new drive, what should you check first.
A cable sequence
B jumpers on the hard drive
C drivers that need to be loaded
D hard drive manufacturer web site information
E None of the above
A system has two IDE hard drives that are each divided into primary and extended partitions, which drive letter is assigned to the primary partition of the second drive?
A C
B D
C E
D F
E None of the above
What X-based tool is available for configuring the X Window system?
A XConfigurator
B XF86Setup
C xf86config
D All of the above
E None of the above
You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?
A jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
B jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch
C jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
D jumper properly, auto-detect in CMOS, regular format
E jumper properly, partition, low level format, high level format
When configuring is a network interface cards without jumpers or plug and play, what is used to set the IRQs?
A DMA
B CMOS
C the OS
D configuration software
E None of the above
You see the message "invalid media device" after installing a new hard drive. What do you do next?
A Format
B Fdisk
C Partition
D Add the OS
E None of the above

Next steps