Related Questions

While working with MS-DOS, which command is used to restore files that were backed up using the BACKUP command?
A COPY
B DISKCOPY
C RESTORE
D STORE
E None of the above
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A You didn
B NVRAM is corrupted.
C The configuration register setting is incorrect.
D The newly upgraded IOS is not compatible with the hardware of the router.
While working with MS-DOS, which command is used to restore only those files modified since the last backup, from the drive A to the currently logged drive or directory?
A RESTORE A: *.*/S
B RESTORE A: *.*/M
C RESTORE A: *.*/N
D RESTORE A: *.*/L
E None of the above
Which command will copy the IOS to a backup host on your network?
A transfer IOS to 172.16.10.1
B copy run start
C copy start tftp
D copy flash tftp
You copy a configuration from a network host to a router's RAM. The configuration looks correct, yet it is not working at all. What could the problem be?
A You copied the wrong configuraion into RAM
B You copied the configuration into flash memory instead
C The copy did not override the shutdown command in running-config
D The IOS became corrupted after the copy command was initiated
The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?
A RAM should be erased and the router restarted
B Flash should be erased and the router restarted
C NVRAM should be erased and the router restarted
D The new configuration should be entered and saved
Because the configuration infor-mation for a DHCP client is received dynamically, you must use which utility to read the current configuration to verify the settings?
A PING
B TRACERT
C ARP
D IPCONFIG
E None of the above
You install Windows NT Server on a computer, making the computer a backup domain controller in an existing domain. After installation, you discover that you used the wrong domain name. What should you do?
A Change the domain name by using Control Panel
B Modify the domain name in the Registry
C Reinstall Windows NT Server
D Change the domain name by using the Emergency Repair disk
E None of the above
After installing a sound card, the system locks up when a parallel port tape backup unit is also used. What is most likely the problem?
A IRQ
B DMA
C defective LPT port
D defective tape driver
E defective sound card.
………. is an essential part of any backup system
A Filter
B Recovery
C Security
D Scalability

Next steps