Because the configuration infor-mation for a DHCP client is received dynamically, you must use which utility to read the current configuration to verify the settings?

Your network is configured as shown in the exhibit. "Engineering! and Salesl have DHCP installed up them." All the servers are Windows 2000 Server computers that use TCP/IP as the only network protocol. The sales department uses one subnet and has servers named Salesl and Sales2. The engineering department uses another subnet and has servers named Engineeringl and Engineering2. Salesl and Engineeringl are configured to act as DHCP servers. The router that joins the two subnets is not RFC 1542 compliant and does not support DHCP/BOOTP relay. You want to allow Salesl and Engineeringl to support client computers on each other's subnets. What should you do?

A

Set the router option in the DHCP Scopes to 192.168.2.1 for Engineeringl and 192.168.1.1 for Salesl

B

On Engineering2 and Sales2, install Routing and Remote Access, and configure RIP as a routing protocol

C

On Engineering2 and Sales2, install and configure the DHCP Relay Agent service

D

Configure Engineering2 and Sales2 as DHCP servers without any scopes

E

None of above

Which of the following best describes the scopes on each DHCP server, in the absence of configuration problems with DHCP addresses, if you use multiple DHCP servers in your environment?

A

Unique to that subnet only

B

For different subnets

C

For no more than two subnets

D

For no subnets

E

None of the above

Which of the following are not the assumptions related to the theory of consumer behaviour as per the cardinal utility approach?
1. Rational consumer
2. Unlimited money income
3. Utility cardinally measurable
4. Diminishing marginal utility of money
5. Constant marginal utility of commodities
6. Maximisation of satisfaction
7. Utility is additive

A

1, 3, 5 and 7

B

2, 4 and 5

C

1, 3, 4 and 5

D

Both 6 and 7

You just finished installing the Dynamic Host Configuration Protocol (DHCP) service on a Windows 2000 Server computer that is a domain controller on your network. What must you do before the DHCP service can start?

A

Authorize the DHCP server in Active Directory

B

Configure a scope, a superscope, and a multicast scope

C

Configure a DHCP address reservation

D

Configure the DHCP server for DNS integration

You are the administrator of contoso.local domain. You organize the domain into organizational units as shown in the EXHIBIT. You configure the local security options and other settings for the default domain policy object You delegate administration of Michigan and Florida OU. You want to prevent those administrators from creating any other group policy objects with settings that conflict with those you configured.What should you do?

A

From the group policy options from the contoso.local domains set the option not override

B

From the group policy options from the Michigan and Florida OU, set the option not override

C

Block the group policy inheritance for the contoso.local domain

D

Block the group policy inheritance for Michigan and Florida OU

E

None of above

Your network contains 10 domain controllers, 10 member servers, and approximately 1,000 client computers. All the servers run Windows 2000 Server, and all the client computers run Windows 2000 Professional. Two of the domain controllers act as DNS servers. Users of client computers use file sharing to grant access to files stored locally. The network has 10 subnets and uses TCP/IP as the only network protocol. You want to configure the network so that all computers can resolve the addresses of all other computers by using DNS. Client computers must be able to register and resolve addresses if a server fails. How should you configure the DNS servers?

A

Configure one server with a standard primary zone for the domain, and configure at least one server with standard secondary zone

B

Configure one server with a standard primary zone for the domain, and configure at least one server with an Active Directory integrated primary zone

C

Configure one server with an Active directory integrated primary zone for the domain, and configure at least one server with a standard secondary zone

D

Configure at least two servers with Active Directory integrated primary zones for the domain

E

Configure at least two servers with standard primary zones for the domain

To constitute a matter of res judicata which of the following conditions must concur?
1. The matter directly and substantially in issue in the subsequent suit or issue must be the same matter which was directly and substantially in issue either actually (section 11, explanation III) or constructively (section 11, explanation IV) in the former suit
2. The former suit must have been a suit between the same parties under whom they or any of them claim. Explanation VI of Section 11 must be read with this condition
3. The parties as aforesaid must have litigated under the same title in the former suit
4. The court which decided the former suit must have been a court competent to try the subsequent suit of the suit in which such issue has been subsequently raised. Explanation II of section 11 is to be read with condition
5. The matter directly and substantially in issue in the subsequent suit must have been heard and finally decided by the court in the first suit. Explanation V of section 11 is to be read with this condition

A

1, 2

B

3, 4

C

2, 4, 5

D

All of these

You use Visual Studio .NET to create an assembly, called XYZAssembly, that will be used by other applications, including a standard COM client application.
You must deploy your assembly on the COM application to a client computer. You must ensure that the COM application can instantiate components within the assembly as COM components. What should you do?

A

Create a strong name of the assembly by using the Strong Name tool (Sn.exe).

B

Generate a type library for the assembly by using the Type Library Importer (Tlbimp.exe). Register the file on the client computer.

C

Generate a registry file for the assembly by using the Assembly Registration tool (Regasm.exe) Register the file on the client computer.

D

Deploy the assembly to the global assembly cache on the client computer. Add a reference to the assembly in the COM client application.

The following questions are based on the information given below: An advertising agency finds that, of its 170 clients, 115 read Indian Express, 110 read The Hindu and 130 read Times of India. Also 85 read Indian Express and Times of India, 75 read Indian Express and The Hindu, 95 read The Hindu and Times of India and 70 read all the three. How many read only The Hindu?

A

5

B

10

C

25

D

35

The following questions are based on the information given below: An advertising agency finds that, of its 170 clients, 115 read Indian Express, 110 read The Hindu and 130 read Times of India. Also 85 read Indian Express and Times of India, 75 read Indian Express and The Hindu, 95 read The Hindu and Times of India and 70 read all the three. How many read Indian Express and Times of India but not The Hindu?

A

10

B

20

C

15

D

30

Because the configuration infor-mation for a DHCP client is received dynamically, you must use which utility to read the current configuration to verify the settings?

Related Questions