Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

To obtain better memory utilization, dynamic loading is used. With dynamic loading, a routine is not loaded until it is called. For implementing dynamic loading ____________
Consider the following statements comparing static RAM with dynamic RAM: In static RAM typical cell requires more number of transistors than the dynamic RAM. Power consumption per bit of static RAM is less than that of dynamic RAM. Dynamic RAM is less expensive than the static RAM. Which of the above statements are correct?
The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is
Which of the following parameters are employed in the design of Trickling filter? a. Hydraulic loading rate b. Organic loading rate c. Detention time d. Weir loading rate
For estimated value of the thrust loading, we got three different values of wing loading. As a designer typically which wing loading should be considered?
Consider the following statements for dynamic characteristics of a measurement system: 1. Fidelity is defined as the degree to which a measurement system indicates changes in the measured quantity without any dynamic error. 2. Dynamic error is the difference between the true value of the quantity changing with time and the value indicated by the measurement system if no static error is assumed. 3. Measuring lag is the retardation in the response of a measurement system to changes in the measured quantity. Which of the above statements are correct?
Which of the following statements is/are incorrect? a)  According to Heckscher-Ohlin, mutually beneficial trade is based on the principle of absolute advantage. b) The law of comparative advantage indicates that each country will specialize in the production of those commodities in which it has the greatest comparative advantage or the least comparative disadvantage. 
Consider the following opinions regarding the advantage and disadvantage of a Mealy model: 1. Advantage: Less number of states (hence less hardware) Disadvantage: Input transients are directly conveyed to the output 2. Advantage: Output remains stable over the entire clock period. Disadvantage: Input transients persist for a long duration at the output. Which of the above is/are correct?
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
The yield point in static loading is __________ as compared to fatigue loading.