Bissoy.com
Doctors Medicines MCQs Q&A

The ratio of the resolved shear stress to the axial stress is called the Schmid factor m.

The ratio of the resolved shear stress to the axial stress is called the Schmid factor m. Correct Answer True

The ratio of the resolved shear stress to the axial stress is called the Schmid factor m. For a single crystal loaded in tension or compression along its axis, m = cosα*cosδ.

Related Questions

Consider the following statements: In case of helical gears, teeth are cut at an angle to the axis of rotation of the gears. 1) Helix angle introduces another ratio called axial contact ratio. 2) Transverse contact ratio is equal to axial contact ratio in helical gears. 3) Large transverse contact ratio does not allow multiple teeth to share the load. 4) Large axial contact ratio will cause larger axial force component Which of the above statements are correct?
Tresca or maximum-shear stress criteria assumes that yielding occurs when the maximum shear stress reaches a value of the shear stress in the uniaxial tension test. Assume the principal stress being σ1, σ2, σ3 where σ1 is largest, and σ3 is the smallest principal stresses. Find the value of minimum shear stress to cause yielding, given that yield stress in tension is equal to σo?
What is the resolved shear stress, when dislocation density in metal is equal to 1012m-2? Given that shear stress needed in the absence of dislocation is 500MPa. Numerical constant is 0.3 and shear modulus is 80GPa, burger vector is 1 nm.
A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is $$\tau $$. The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be
Which of the following factors are affecting critical shear stresses? 1. Purity of metals reduces the critical shear stress 2. Surface films greatly enhance the critical shear stress 3. Rise in temperature 4. Rate of deformation and the extent of initial deformation also help in raising the critical shear stress
When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)
Match the following in Column X with Column Y: Column X Column Y  P. In a triaxial compression test, with increase of axial strain in loose sand under drained shear condition, the volumetric strain  I. decreases  Q. In a triaxial compression test, with increase of axial strain in loose sand under undrained shear condition, the excess pore water pressure  II. Increase  R. In a triaxial compression test, the pore pressure parameter “B” for a saturated soil  III. remains same  S. For shallow strip footing in pure saturated clay, Terzaghi’s bearing capacity factor (Nq) due to surcharge  IV. is always 0.0.      V. is always 1.0.      VI. is always 0.5. Which one of the following combinations is correct?
The Rheological behaviour of concrete, when represented by shear stress vs rate of shear, is characterized as Where : τ shear stress, Τ0 = (initial) yield value, μ = at-point plastic viscosity, γ̇ = at point rate of shear.
If nominal shear stress $${\tau _{\text{v}}}$$ exceeds the design shear strength of concrete $${\tau _{\text{c}}}$$, the nominal shear reinforcement as per IS : 456-1978 shall be provided for carrying a shear stress equal to
Shear stress versus shear rate behavior of four different types of fluids (I, II, III and IV) are shown in the figure below.
Basic Principles of Biotechnology mcq question image
Which one of the following options is correct?