Bissoy.com
Doctors Medicines MCQs Q&A

The viscosity of the resin in the resin consolidation should not be_____

The viscosity of the resin in the resin consolidation should not be_____ Correct Answer Excessive

Viscosity of resin should not be excessive. Resin injection is simply considered as artificial consolidation of sand. Plastic resins are injected into the formation sand grains that help in consolidating the formation sands.

Related Questions

Consider the following statements: 1. Secondary consolidation occurs at constant effective stress. 2. Secondary consolidation is related to dissipation of pore water pressure 3. Secondary consolidation occurs due to the readjustment of soil skeleton after a disturbance during primary consolidation. 4. Rate of secondary consolidation is controlled by the viscous adsorbed layer surrounding clay particle in soil. Which of the above statements are correct?
Consider the following statements: 1. Secondary consolidation of soil follows Terzaghi’s one-dimensional theory of consolidation. 2. Consolidation is a function of total stress. 3. Even after complete dissipation of excess pore pressure, the soil undergoes a little more consolidation. Which of the above statements is/are correct?
Consider the following statements: 1) Secondary consolidation results due to prolonged dissipation of excess hydrostatic pressure 2) Primary consolidation happens under expulsion of both air and water from voids in early stages 3) Initial consolidation in the case of fully saturated soil mainly due to compression of solid particles 4) Primary consolidation happens more quickly in coarse-grained soils than in fine-grained soils Which of the above statements are correct?
Clay layer A with single drainage and coefficient of consolidation Cv takes 6 months to achieve 50% consolidation. The time taken by clay layer B of the same thickness with double drainage and coefficient of consolidation $$\frac{{{\text{Cv}}}}{2}$$ to achieve the same degree of consolidation is
Resin P, on further heating turns into completely cross-linked resin Q, which is totally insoluble and infusible. Resin P is slightly heat fusible and insoluble in alkalis and alcohols but partly soluble in acetone. What are the names of resin P and Q?
Correct viscosity of furnace oil at the burner tip for proper atomisation is about 25 centistokes. To reduce the viscosity of high viscosity furnace oil (250 centistokes) to the correct atomisation viscosity (i.e. 25 cst), it should be preheated to about____°C.
The following Four statements (S1, S2, S3, S4) in connection with soil behaviour are given. S1: Consolidation is a function of total stress S2: Permeability of Coarse grained soil is inversely proportional to the specific surface at a given porosity. S3: For a fully saturated soil the pore pressure parameter is equal to zero. S4 : Terzaghi's theory of consolidation considers only primary consolidation. Which of the above statement(s) is /are incorrect?
In Newton's law of viscosity, which states that the shear stress is proportional to the __________ Co-efficient of viscosity is called dynamic or absolute viscosity(where, V = velocity, Vg = velocity gradient ).
In Newton's law of viscosity, which states that the shear stress is proportional to the __________ co-efficient of viscosity is called dynamic or absolute viscosity (where, V = velocity, $${{\text{V}}_{\text{g}}}$$ = velocity gradient).
In Terzaghi’s Theory of one dimensional consolidation, the change in thickness of a layer during consolidation is ___________