Bissoy.com
Doctors Medicines MCQs Q&A

Which of the following represents the formula for the depth of cut? d1=diameter of work surface before machining and d2=diameter of the machined surface

Which of the following represents the formula for the depth of cut? d1=diameter of work surface before machining and d2=diameter of the machined surface Correct Answer (d1-d2)/2

(D1-d2) – this is the formula for depth of cut. Here both d1 and d2 are diameters and expressed in mm.

Related Questions

If the diameter of the work surface before machining(d1) is 100 mm and diameter of the machined surface(d2) is 50 mm. Then the depth of the cut is______ mm.
Consider the following statements for a power shovel:
(i) Output can be increased by reducing the angle of swing for a given depth of cut.
(ii) For a given angle of swing, output will be maximum at optimum depth of cut.
(iii) Output can be increased by keeping the depth of cut less than optimum depth.
(iv) Output can be increased by increasing the size of shovel.
Depth of cut is the _______ distance between machined surface and non-machined surface of the workpiece.
Arrange the processes in the increasing order of their maximum material removal rate. Electrochemical Machining (ECM) Ultrasonic Machining (USM) Electron Beam Machining (EBM) Laser Beam Machining (LBM) and Electric Discharge Machining (EDM)
Last year, there were three sections in a competitive exam. Out of them 33 students cleared the cut-off in Section A, 34 students cleared the cut-off in Section B and 32 students cleared the cut-off in Section C. 10 students cleared the cut-off in section A and section B, 9 cleared the cut-off in section B and section C and 8 cleared the cut-off in section A and section C. The number of students who cleared only one section was equal and was 21 for each section. How many students cleared all the three sections?
Given below are two quantities named 1 and 2. Based on the given information, you have to determine the relationship between the two quantities. You should use the given data and your knowledge of Mathematics to choose between the possible answers. Quantity 1: P and Q can do a work in 6 days and Q and R can do a work in 60/7 days and P and R can do a work in 20/3 days. If Q and R work for first 2 days and left the work. Find the total time taken by P to complete the remaining work. Quantity 2: A and B can do a work in 8/3 days, B and C can do the same work in 3 days and A and C can do the same work in 24/5 days. In what time C alone can complete the work?
The depth of cut is the_____ distance measured from the machined surface to the surface of the work piece, which is uncut.
The depth of centre of pressure (h) for a vertically immersed surface from the liquid surface is given by (where IG = Moment of inertia of the immersed surface about horizontal axis through its centre of gravity, A = Area of immersed surface, and x = Depth of centre of gravity of the immersed surface from the liquid surface)
The depth of centre of pressure (h) for a vertically immersed surface from the liquid surface is given by (where $${I_{\text{G}}}$$ = Moment of inertia of the immersed surface about horizontal axis through its centre of gravity, A = Area of immersed surface and x = Depth of centre of gravity of the immersed surface from the liquid surface)
Five men A, B, C, D and E can do a piece of work in 20, 10, 30, 40 and 50 days respectively. A, B, and C started the work and they work for 2 days after which A and B left the work and D joins the work. D and C work another 3 days together after which C leaves and E joins the work. Find in how many days E and D completed the rest of the work.