Bissoy.com
Doctors Medicines MCQs Q&A

The mixing length for a 2-D turbulent boundary layer depends on ____________

The mixing length for a 2-D turbulent boundary layer depends on ____________ Correct Answer the distance from the wall and von Karman’s constant and dimensionless distance

The mixing length for a 2-D turbulent boundary layer is given by κy. Where, κ is the von Karman’s constant which is equal to 0.41. y is the distance from the wall. y+ is the dimensionless distance.

Related Questions

Some small cubes of same height 7 cm but variable length and width are put inside a large cuboid of height 21 cm. Length and width of cuboid is 32 cm and 24 cm, respectively. Small cubes are put such that cubes at the bottom most layer is of similar base area; second layer contains all the cubes of similar base area and third layer have all the cubes of similar base area. Which of the following statement(s) given below is / are TRUE? A: If side of each small cubes at bottom most layer is 8 cm, then maximum number of small cubes that can be put at bottom most layer is 12. B: If maximum of 48 cubes can be put at second layer, then side of each cube at second layer is 6 cm. C: If side of each small cubes at third layer is 1.6 cm, then maximum number of small cubes that can be put at third layer is 300.
The boundary layer thickness at a distance of l m from the leading edge of a flat plate, kept at zero angle of incidence to the flow direction, is O.l cm. The velocity outside the boundary layer is 25 ml sec. The boundary layer thickness at a distance of 4 m is (Assume that boundary layer is entirely laminar)
A wave is first reflected by a boundary P and then by a boundary Q without dissipating energy. If the boundary P is rigid and the boundary Q is non-rigid, then find the fraction of the amplitude of the reflected wave by boundary P to the reflected wave by boundary Q.
What is the mixing length for the outer layer of a 2-D turbulent boundary layer?
When there’s flow over a flat plate, there’s laminar boundary layer at the leading edge followed by turbulent boundary layer.
The laminar boundary layer thickness in zero pressure gradient flow over a flat plate along the x-direction varies as x0.5 while the thickness of turbulent boundary layer varies as (where, x = distance from the leading edge)
Product X is produced by mixing chemical A and chemical B in the ratio of 5 : 4. Chemical A is prepared by mixing two raw materials, P and Q, in the ratio of 1 : 3. Chemical B is prepared by mixing raw materials, Q and R, in the ratio of 2 : 1. Then the final mixture is prepared by mixing 8640 units of product X with water. If the concentration of the raw material Q in the final mixture is 50%, how much water had been added to product X?
In case of water (Prandtl number ≈ 6) flowing over a flat plate heated over the entire length, the thermal boundary layer thickness as compared to hydrodynamic boundary layer thickness is
The nature of normal grain growth in the presence of a second phase deserves special consideration. The moving boundaries will be attached to the particles exert a pulling force on the boundary restricting its motion. Therefore if the boundary intersects the particle surface at 90° the particle will feel a pull of (2πrγcosΘ)*sinΘ. This will be counterbalanced by an equal and opposite force acting on the boundary. As the boundary moves over the particle surface Θ changes and the drag reaches a maximum value, this happens when Θ becomes______
Turbulent boundary layer is considered to be a combination of inner and outer layer.